686267

Weldkar MIG 5040 F SYNERGIC INVERTER WELDER Manual

75
Zoom out
Zoom in
Previous page
1/84
Next page
75
Probleme Remede
L’indicateur de courant ne s’allume
pas, le ventilateur ne tourne pas,
pas de courant de soudage.
1. Vérifier que l’interrupteur principal est sur Marche.
2. Vérifier que le câble d’alimentation est bien connecté dans la prise.
Le ventilateur est en marche, il
n’est pas l’objet d’instabilité par la
commande de courant de soudage,
le courant est fort, parfois faible.
1. Le câble de courant est endommagé, remplacez le.
2. Mauvaises connexions, contrôler les fiches et les prises.
L’indicateur de courant s’allume, le
ventilateur tourne normalement, pas
de courant de soudage.
1. Vérifier pour tous les connecteurs dans l’appareil s’il existe un problème.
2. Une cause peut être un défaut de circuit.
3. L’indicateur d’alarme est allumé.
(1) l’appareil est en état de protection pour cause de surchauffe. Dans
ce cas, ne pas éteindre l’appareil, mais attendre que le ventilateur ait
refroidi l’appareil à une température raisonnable. Une fois l’indicateur
éteint, vous pouvez poursuive votre travail.
(2) Vérifier si le contacteur thermique est endommagé. Si c’est le cas,
le remplacer.
La pince de masse s’échauffe. Le courant nominal de la pince de masse est trop bas, la remplacer par une
pince plus grande.
Fortes éclaboussures en cas de
soudage manuel.
La polarité de sortie est excessive. Inverser le connecteur du courant sortant.
SOUDURE MMA
engdeu
fra
ned
… 75 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Weldkar MIG 5040 F SYNERGIC INVERTER WELDER at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Weldkar MIG 5040 F SYNERGIC INVERTER WELDER in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info