Recall a measurement
Pressing the Memory button (MEM) will display the temperature in memory with a MEM
indicator. Memory is available directly from the off state, when no measurement is
displayed, or immediately following a new measurement if a comparison to the prior
reading is needed. Once the thermometer is powered off or a new measurement is
initiated, the last temperature taken becomes the reading in memory.
1. Press and release MEM.
The LCD displays the temperature stored in the thermometer's memory for 10
seconds.
2. Press and hold MEM for 3 seconds to force the measurement on the display to
memory and clear the display.
The thermometer beeps three times to indicate the measurement is moved to
memory and the thermometer is ready to take a new measurement with a clear
display.
Note It is not required to force a reading to memory. A new
reading will automatically move to memory when the
thermometer turns off or a new measurement is initiated.
Use the timer
1. Press and release the Timer button.
The timer is activated. Audible beeps sound at 0, 15, 45, and 60 seconds.
2. Press the Timer button again to exit at any time.
After the full 60 second cycle, the thermometer turns off automatically after 2
seconds.
Change the temperature scale
1. Press C/F to temporarily view the measurement in the alternate temperature scale.
This scale conversion feature is available any time a temperature value is displayed,
and can be used to continuously alternate between temperature scales.
2. Press and hold both the MEM and C/F buttons for 3 seconds to change the default
scale.
Three beeps sound to confirm the setting is changed.
The alternate scale remains until one of the following occurs, returning the thermometer
to the default temperature scale:
• The C/F button is pressed again.
• A new measurement is taken.
• Any other action is taken.
• The thermometer turns off.
Directions for use Using the thermometer 9
