813696
33
Zoom out
Zoom in
Previous page
1/36
Next page
Montage- und Betriebsanleitung
WWP S 22 IB
3 Stromlaufpläne
452235.66.02 · 10/2013 · Rei XI
R5 Fühler für 2ten Heizkreis Sensor for heating circuit 2 Sonde pour 2e circuit de chauffage
R6 Vorlauffühler Primärkreis
R7 Codierwiderstand Coding resistor Résistance de codage
R9 Vorlauffühler Heizkreis Flow sensor for heating circuit Sonde aller circuit de chauffage
R13* Fühler regenerativ, Raumfühler, Fühler 3. Heizkreis Renewable sensor, room sensor, sensor for heating
circuit 3
Sonde mode régénératif, sonde d'ambiance, sonde
3ème circuit de chauffage
R25 Drucksensor Kältekreis - Niederdruck pO Pressure sensor for refrigerating circuit - low pressure
pO
Capteur de pression circuit réfrigérant - basse
pression pO
R26 Drucksensor Kältekreis - Hochdruck pc Pressure sensor for refrigerating circuit - high
pressure pc
Capteur de pression circuit réfrigérant - haute
pression pc
T1 Sicherheitstrenntransformator 230/24 V AC-28 VA Safety isolating transformer 230/24 V AC-28 VA Transformateur sectionneur de sécurité 230/
24 V AC-28 VA
X1 Klemmleiste Einspeisung Terminal strip, infeed Alimentation bornier
X2 Klemmleiste Spannung = 230 V AC Terminal strip voltage = 230 V AC Tension bornier = 230 V AC
X5* Busverteilerklemme Bus distribution board terminal Réglettes Bus
X3 Klemmleiste Kleinspannung < 25 V AC Terminal strip, extra-low voltage < 25 V AC Faible tension bornier < 25 V AC
Y4 Magnetventil Heißgas-Bypass Solenoid valve for hot gas bypass Électrovanne dérivation gaz chaud
* Bauteile sind bauseits beizustellen Components must be supplied by the customer Composants à fournir par le client
[ ] Flexible Beschaltung - siehe Vorkonfiguration (Ände-
rung nur durch Kundendienst!)
Flexible switching - see pre-configuration (changes
by after-sales service only!)
Commande flexible - voir pré-configuration
(modification uniquement par le SAV !)
–––––– werksseitig verdrahtet Wired ready for use câblé en usine
- - - - - - bauseits bei Bedarf anzuschließen To be connected by the customer as required À raccorder par le client au besoin
ACHTUNGACHTUNG
An den Steckklemmen J1 bis J11,
J19, J20; J23 bis J26 und der
Klemmleiste X3 liegt Kleinspannung
an. Auf keinen Fall darf hier eine
höhere Spannung angelegt werden.
ATTENTION
Plug-in terminals J1 to J11, J19, J20;
J23 to J26 and terminal strip X3 are
connected to extra-low voltage. A
higher voltage must on no account
be connected.
ATTENTION !
Une faible tension est appliquée aux
bornes enfichables J1 à J11, J19,
J20 ; aux bornes J23 à J26 et au
bornier X3. Ne jamais appliquer une
tension plus élevée.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Weishaupt WWP S 22 IB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Weishaupt WWP S 22 IB in the language / languages: German as an attachment in your email.

The manual is 1.9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Weishaupt WWP S 22 IB

Weishaupt WWP S 22 IB User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info