813690
149
Zoom out
Zoom in
Previous page
1/224
Next page
Montage- und Betriebsanleitung
Gas-Brennwertgerät WTC-GW 15 … 32-B
10 Fehlersuche
83307201 1/2023-10 Et 149-224
10.5 Umwälzpumpe UPM3 mit LED-Anzeige
Die LED an der internen Umwälzpumpe zeigt den Betriebsstatus der Pumpe an.
LED Beschreibung Behebung
grün blinkend Steuerung über PWM-Signal
grün keine Steuerung über PWM-Signal
rot Fehlermeldung
Rotor blockiert Neustart der Pumpe abwarten.
Spannungsversorgung unterbrechen.
Blockierung beseitigen, dabei Deblockierschrau-
be mit Kreuzschlitzschraubendreher(Größe2)
ca. 5 mm eindrücken, dann links und rechts dre-
hen, ggf. vorsichtig lösen.
Pumpe prüfen, ggf. austauschen.
Spannungsversorgung zu niedrig Spannungsversorgung prüfen.
Elektronikfehler Spannungsversorgung prüfen.
Pumpe austauschen.
10.6 Betriebsprobleme
Folgende Fehler dürfen nur durch dafür qualifiziertes Fachpersonal behoben werden:
Beobachtung Ursache Behebung
Brenner brummt/pfeift Brenneroberfläche verschmutzt/ beschä-
digt, Gewebe lose
Brenneroberfläche prüfen, ggf. reini-
gen oder austauschen [Kap.9.3].
Ansaugschalldämpfer fehlerhaft Verbindung zwischen Ansaugschall-
dämpfer und Gebläse prüfen.
Ansaugschalldämpfer prüfen, ggf.
austauschen.
schlechtes Startverhalten Abstand Zündelektrode falsch, Zünd-
elektrode beschädigt
Zündelektrode austauschen
[Kap.9.4].
Zündung erfolgt zu spät Flammenbildungszeit zu lang, Para-
meter 2.3.1Korrektur Gas-
menge beim Start schrittweise
erhöhen, dabei CO-Gehalt beachten
[Kap.6.6.2.3].
Abgasgeruch Füllstand Siphon zu gering Siphon füllen [Kap.9.5].
Pumpenleistung zu gering Umwälzpumpe auf falsche Betriebsart
eingestellt
Betriebsart der Pumpe prüfen.
Nach Austausch vom Gaskom-
biventil keine Flammenbildung
Wert von Parameter Gasventil
Offset Speicher fehlerhaft
Parameter 2.3.6Gasventil
Offset Speicher ändern
[Kap.6.6.2.3].
149


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Weishaupt WTC-GW 25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Weishaupt WTC-GW 25 in the language / languages: German as an attachment in your email.

The manual is 8.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Weishaupt WTC-GW 25

Weishaupt WTC-GW 25 User Manual - Dutch - 224 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info