579141
14
Zoom out
Zoom in
Previous page
1/28
Next page
WWW.WEBER.COM
®
14
1
2
4
3
5
PREPARING TO USE YOUR BARBECUE -
WHEN CONNECTED TO A CARTRIDGE
m DANGER
Do not use an open flame to check for
gas leaks. Be sure there are no sparks or
open flames in the area while you check
for leaks. Sparks or open flames will
result in a fire or explosion, which can
cause serious bodily injury or death and
damage to property.
m WARNING: The gas connections
of your gas barbecue have been
factory-tested. We do, however,
recommend that you leak-check all gas
connections before operating your gas
barbecue.
m WARNING: Perform these leak checks
even if your barbecue was dealer- or
store-assembled.
m WARNING: You should check for gas
leaks every time you disconnect and
reconnect a gas fitting.
NOTE: All factory-made connections have been
thoroughly checked for gas leaks and the burners have
been flame-tested. As a safety precaution, however,
you should check all fittings for leaks before using your
Weber® gas barbecue. Shipping and handling may
loosen or damage a gas fitting.
CHECKING FOR GAS LEAKS AFTER
CONNECTING A CARTRIDGE
You will need: A spray bottle or brush or rag and a soap-
and-water solution. (You can make your own soap-and-
water solution by mixing 20% liquid soap with 80% water;
or, you can purchase solution in the plumbing section of
any hardware store.)
A) Make sure the burner control knob is turned off by
pushing it in and turning it clockwise to the off (
)
position (1).
B) Turn gas supply on by turning the regulator gas
control valve anti-clockwise (2).
m WARNING: Do not ignite burner when
leak-checking.
C) To check for leaks, wet fittings with the soap-and-
water solution, using a spray bottle, brush or rag. If
bubbles form, or if a bubble grows, there is a leak.
Apply the soap-and-water solution to the following
connections:
a) Regulator-to-cartridge connection (3).
m WARNING: If there is a leak at
connection (3), remove the cartridge.
DO NOT OPERATE THE BARBECUE.
Install a different cartridge and recheck
for leaks with soap-and-water solution.
If a leak persists after installing a
different cartridge, turn off the gas.
DO NOT OPERATE THE BARBECUE.
Contact the Customer Service
Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
b) Valve-to-regulator hose connection (4).
c) Regulator hose-to-regulator connection (5).
m WARNING: If there is a leak at
connections (4 or 5), turn off the gas.
DO NOT OPERATE THE BARBECUE.
Contact the Customer Service
Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
D) When leak checking is complete, turn gas supply off at
the source and rinse connections with water.
NOTE: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Now you are ready to use your barbecue.
WHAT IS A LEAK CHECK?
The fuel system in your
barbecue features
connections and fittings. A
leak check is a reliable way
to make sure that no gas
is escaping from any of the
connections or fittings.
Although all factory-made
connections have been
thoroughly checked for
gas leaks, it’s important to
perform a leak check before
using your barbecue for the
first time, as well as anytime
you disconnect and reconnect
a fitting and each time you
perform routine maintenance.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Weber Q 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Weber Q 2000 in the language / languages: English as an attachment in your email.

The manual is 7,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Weber Q 2000

Weber Q 2000 User Manual - German - 28 pages

Weber Q 2000 User Manual - Dutch - 28 pages

Weber Q 2000 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info