9
Lighting Your Gas Grill
ƽWARNING: Always remove the lid before lighting your grill.
ƽCAUTION: Clearance from combustible material 6 inches from sides,
24 inches from top.
1. Push down the burner control valve and turn anti-clockwise to HIGH.
2. Hold the handle of the bottom unit while pushing the igniter button 2
or 3 times.
3. Check to see if the burner is lit by looking through the viewing hole in the
Flavorizer
®
Bar.
ƽWARNING: If burner does not light, turn burner control valve OFF,
wait 5 minutes for the gas to clear, then try again.
ƽDANGER
Do not use an open flame to check for gas leaks. Be sure there are
no sparks or open flames in the area while you check for leaks.This
will result in a fire or explosion which can cause serious bodily
injury or death, and damage to property.
Check for Gas Leaks
1. Check the connection between the tank and the regulator for gas
leaks. Mix a couple of tablespoons of liquid detergent with an equal
amount of water.
2. Be sure to leave the burner control valve in the LOCK/OFF position. Wet
the connection with the soap solution and watch for bubbles. If bubbles
form or if a bubble grows, there is a leak.
3. If there is a leak, check the fitting, make sure it is tight, recheck
the connections.
4. Check for gas leaks each time you disconnect or connect the gas supply.
