Manual Webasto Dual Top ST 8 (page 5 of 19) (English)

802472

Zoom out

Zoom in

1/19

Operating instructions | 4

9026381C Dual Top ST 6 _ 8 - OI 5 / 19

*The high-power option with 2,000 W cannot be used in sum-

mer mode (Dual Top ST 8).

3.2 Winter mode (heating without hot

water production)

In this mode the heater provides hot air.

Heat is produced by a diesel powered burner (Dual Top ST 6 and

8), an electric heater, or a combination of both

(Dual Top ST 8).

For Dual Top ST with a manual control panel:

The desired interior temperature can be adjusted with the in-

terior temperature selector (5 to 35 °C).

For Dual Top ST with a programmable control panel:

To adjust the desired interior temperature, push button (1)

or (2) (5 to 35 °C).

If the combustion burner is selected as heat source, then the

device automatically selects the burner setting, modulating

between 1,500 W and 6,000 W, depending on the output re-

quirement (calculated from difference between selected temper-

ature and current interior temperature).

The amount of heat is regulated to reach the preselected in-

terior temperature quickly. After which only a limited amount of

power is needed to maintain the interior temperature.

If electricity is used as source of energy, the electric heater heats

the air and water at low or high power, depending on the selec-

tion. Electricity is taken from an external power supply.

(Dual Top ST 8).

If the burner and the electric heater provide the heat, priority is

given to the electric heater. This means that the electric heater

runs at low or high power (depending on the selection) and the

burner provides the rest of the heat if necessary.

(Dual Top ST 8).

You can heat the interior with or without water in the

boiler.

3.3 Winter mode (heating with hot

water production)

In this mode the heater heats the interior and produces hot wa-

ter.

Heat is produced by a diesel powered burner (Dual Top ST 6 and

8), an electric heater, or a combination of both

(Dual Top ST 8).

For Dual Top ST heaters with a manual control panel:

The desired interior temperature can be adjusted with the in-

terior temperature selector (5 to 35 ºC).

For Dual Top ST heaters with a programmable control panel:

To adjust the desired interior temperature, push button (1)

or (2) (5 to 35 °C).

If the combustion burner is selected as heat source, then the

device automatically selects the burner setting, modulating

between 1,500 W and 6,000 W (Dual Top ST 6) or 1,500 W and

8,000 W (Dual Top ST 8), depending on the output requirement

(calculated from difference between selected temperature and

current interior temperature).

The amount of heat is regulated to reach the pre-selected in-

terior temperature quickly. After which only a limited amount of

power is needed to maintain the interior temperature.

A water temperature sensor controls the water temperature,

while an interior temperature sensor controls the interior tem-

perature.

Due to variable operating and environmental influences, small

water temperature deviations are possible.

Only for Dual Top ST 8: If you use electricity as source of en-

ergy, the electric heater heats the air and water at low or high

power, depending on the selection. Electricity is taken from an

external power supply.

If the burner and the electric heater provide the heat, priority is

given to the electric heater. This means that the electric heater

runs at low or high power (depending on the selection) and the

burner provides the rest of the heat if necessary.

3.4 Advanced functions

nMenu driven user guidance in 6 languages.

nProgrammable timer: The device has two freely program-

mable heating programs, 24/7.

See chapter4.5, "Programming timer" on page 11.

nRemote control by Webasto Telestart (optional control).

See chapter4.6, "Remote control" on page 13.

nBoiler drainage: possibility to drain the boiler manually from

the control panel or automatically for frost protection.

See chapter4.7, "Frost" on page 13.

nFrost protection mode: protects the boiler against frost.

See chapter4.7.4, "Frost protection" on page 15.

nTextual fault information: when a fault occurs, the control

panel displays a fault message with a fault number and

brief description to inform the user about the kind of fault.

See chapter7.1, "Fault Message output" on page 17.

4 Operating instructions

4.1 General

You must observe the operating instructions and chapter2,

"Maintenance and safety information" on page 3 before start-

ing. The vehicle owner is responsible for the correct operation

of the device.

CAUTION

Before first use, you must disinfect and rinse the entire

water supply system with clean, fresh drinking water

(see chapter6, "Maintenance" on page 16).

If the heater is not used, always drain the water contents to

avoid frost problems and to avoid contamination with micro-or-

ganisms.

Also drain the water before any repair or maintenance work on

the vehicle because the electrical safety / drainage valve may

open when the device is switched off!

NOTE

When the heater is new, there may be an unfamiliar

smell during the first couple of operation cycles.

NOTE

During continuous operation at low output levels,

Webasto recommend that the heater be operated at

full load approximately once a month for 15 minutes to

burn possible deposits in the burner.

4.1.1 Interior temperature sensor

To measure the room temperature, a remote interior temperat-

ure sensor is located in the vehicle. The location of the sensor is

determined by the installer, and depends on the vehicle type

and interior layout.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Webasto Dual Top ST 8 in the language / languages: English as an attachment in your email.

The manual is 6.42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Webasto Dual Top ST 8

Webasto Dual Top ST 8 User Manual - German - 21 pages

Webasto Dual Top ST 8 User Manual - Dutch - 21 pages

Webasto Dual Top ST 8 User Manual - French - 21 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Webasto Dual Top ST 8 Manual

Product: