Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: info@aktobis.de
Instructions for use:
1. Operational environment
- The maximum operating temperature should not exceed +40°C !
- The unit should not be operated at altitudes higher than 1,000 metres above sea level !
2. Commissioning
2.1. Position the blower so that the air stream flows in the desired direction after switching on. When doing so,
please note that the front (exhaust air) of the blower is identified by the trademark. The on/off switch is located
above the blower drum.
Adjustment of the air flow:
The fan head can be swivelled from top to bottom and thus the air flow can be tilted in any desired direction. To
change the airflow in a desired lateral direction, it is sufficient to slightly change or adjust the standing position
of the unit.
2.2. Now insert the mains plug properly into the socket.
2.3. The fan is switched on by a rotary switch located on top of the drum of the unit. Point the rotary switch in the
direction of the arrow to the desired operating position.
0 = OFF
1 = ON in weak fan stage
2 = ON in strong fan stage
3. Maintenance, Cleaning & Storage
Please always disconnect the mains plug first and allow the fan to run down completely before carrying out any
cleaning activities on your appliance !
3.1. maintenance:
A professional should treat the blower axle with lubricating oil approx. every 1,500 operating hours to ensure
optimum operation and a long blower service life.
3.2 Cleaning:
- Use a soft and damp cloth to clean the outside of the unit.
- Only use mild cleaning agents to clean your blower.
- Please make sure that water does not get inside the motor or the electrical control box at any time !
- Be careful not to accidentally adjust (bend) the angle of the rotor blades when cleaning the unit.
3.3 Storage:
- We recommend that you cover the unit for storage or, ideally, pack it in its original box.
- Store the unit in a dry and sufficiently ventilated place/space.
4. Other operating instructions
4.1. Do not disconnect the mains plug by pulling on the power cable !
4.2. Do not use insect spray, oil spray, paint spray, etc. near the blower. This may cause damage to the unit or
even fire !
4.3. Do not place the appliance on sloping or uneven ground !
