807058

WDH IFH15 Manual

8
Zoom out
Zoom in
Previous page
1/8
Next page
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
Power Fan Heater WDH-IFH15 (15kW)
Dear Customer,
You have chosen a high-quality product. To ensure that you get a lot of enjoyment from this product, here are a few
more tips:
Information relevant to energy consumption:
This product is only suitable for well-insulated rooms or for occasional use.
In case of any problems:
We hope that the unit meets your expectations! If, despite the greatest possible care, there should ever be cause
for complaint, please contact us briefly, as we are very concerned about your satisfaction and would like to clear up
any misunderstanding.
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
During the first operation:
As the heating elements are covered with a light film of oil at the factory for reasons of protection, you will notice a
slight smell of burning and possibly also some smoke during the first operation. This is quite normal at first and is
caused by the fact that the oil film is now burnt by the heating elements during operation.
Important safety instructions:
- Only use the recommended voltage for operating the unit !
- The heater is not suitable for use outdoors or in other wet or damp environments !
- Please note that the heater can become very hot during operation, so keep a sufficient distance from
flammable or easily combustible objects at all times !
- Do not place the heater directly next to a power socket !
- Do not use a timer or automatic on/off switch in conjunction with this heater !
- Never use the heater on moving surfaces, objects or vehicles ! There is a risk that the heater may tip over.
- It is recommended to use a separate power source (socket) only for the supply of the heater. (Please do not
use multiple sockets to operate the heater) !
Furthermore, please ensure that the power cable is always laid with sufficient distance to the heat source.
- Supervise the heater when children are near the appliance !
- Be aware of electricity, never walk into or insert objects into the appliance ! Never reach near the plug or socket
with wet hands !
Never touch the heater or the power cables with wet hands!
- Do not place any objects on the heater !
- Do not block the supply and/or exhaust air of the unit and please ensure sufficient space/clearance around the
unit !
- Ensure that there is sufficient air supply to the unit, otherwise it can lead to a reduction in performance and, in
the worst case, to overheating and/or fire !
- Only qualified personnel or electricians are allowed to open the unit !
- Make sure that no moisture gets into or onto the unit !
- Make sure that the power cable is completely unfolded before connecting it to the socket !
- Make sure that the plug is cleanly and properly connected to the socket before using the appliance !
- Make sure that highly flammable substances (e.g. gases/oils etc.) are never in the vicinity of the unit !
- If the connecting cable of this appliance is damaged, it must be replaced by the manufacturer or its after-sales
service or a similarly qualified person in order to avoid hazards.
- This appliance is not intended to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and/or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
- If you are not going to use the unit for a long time, switch it off and disconnect the mains plug !
Please switch off the unit immediately and disconnect it from the mains/power supply if anything
seems to be wrong !!! In this case, please contact a specialist and do not try to repair the unit
yourself !!!
Example: Fan does not run during operation, you notice sparks or the fuse has blown.
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
Description of the unit parts:
Front: Back:
1 Reset button (reset button) 6 Thermostat sensor
2 Thermostat knob 7 Power connection (400 V)
3 Operating strength adjustment knob (ON/OFF) 8 Lid holder of the Power
4 Heat sensor cable
5 Standing foot / transport handle
Description of the control panel:
1. Operating strength adjustment knob 2. Thermostat control dial
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
Instructions for use:
1. Commissioning
1.1. You need a suitable power cable for connection. This connection cable is not included in the scope of delivery,
please use a connection cable with the following specification for this purpose:
(1) Five-pole power connection 380V/415V (50/60Hz, 32A)
(2) Five-core power cable H07RN-F (5G4 mm²)
(3) Five-pole power plug 380V/415V (50/60Hz, 32A)
1.2. Connect the power cable properly to the heater. To do this, open the protective flap of the five-pole power
connection (see Fig. 1). Now connect the plug head of the power cable to the socket provided for this purpose
on your heater (see Fig. 2). It is important that the power connection is firmly seated in the connection socket
(4) and that the nipple of the protective flap engages in the recess provided in the heater (3). Finally, connect
the power plug (5) properly to a power socket.
Fig. 1
Fig. 2
Fig. 3
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
1.3. Select the desired unit power with the operating power adjustment knob (left-hand knob).
= Off
= Fan operation
= Level 1 (low operating power with 5 kW heating power)
= Level 2 (medium operating strength with 10 kW heating output)
= Level 3 (highest operating strength with 15 kW heating power)
1.4. Now set the desired temperature switch-off point (0 ~ 40° C) with the stepless thermostat control dial (right-
hand knob). It is best to do this as follows: Turn the thermostat knob to the highest temperature (MAX.) and let
the heater run until your desired temperature value is reached. Now turn (adjust) the control downwards
towards the minimum until the heating function switches off automatically. Now leave the control dial
(thermostat) in this position and whenever it gets colder in the room, the heating rod automatically starts to heat
and when the adjusted temperature is reached again, the heating rod automatically switches off again!
Note: The fan of the heater is not controlled by the thermostat. If the selected target temperature is reached, the
heating element switches off automatically, but the fan continues to run !
2. Switch off
To switch off the unit, turn the stepless thermostat control knob (right-hand knob) to minimum (MIN) and let the unit
run in fan mode for about 5 minutes to allow it to cool down. Afterwards, also turn the operating strength adjustment
knob to "0" to switch off the unit completely.
3. Manually resetting the high-voltage heater
In case of malfunction of the heater, e.g. no heat output, overheating or other problems, the following procedure is
recommended:
3.1 Unplug the heater from the mains and let it cool down if necessary.
3.2 Check that the operating strength adjustment knob is in the OFF position and the
thermostat control dial is turned to MIN.
3.3 Take a pointed pen/object and press the reset button until you hear a short click
(see fig.). This resets or zeroes the electrical system of the heater.
3.4 Now you can reconnect the heater to the mains plug and the heater should work
properly again.
4. Cleaning & Storage
Always unplug the heater from the mains and allow it to cool down completely before cleaning it !
4.1 Cleaning the housing:
- Use a soft and damp cloth to clean the outside of the housing.
- Use only mild cleaning agents to clean your heater and no aggressive cleaning agents, these can damage your
appliance !
- Please make sure that no water gets inside your heater at any time !
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
4.2 Storage:
- We recommend that you repack the unit in its original box for storage.
- Store the heater in a dry and sufficiently ventilated place/space.
5. Other operating instructions
5.1. Do not disconnect the mains plug by pulling on the power cable !
5.2. Do not use insect repellent, oil spray, paint spray, etc. near the heater. This
may cause damage to the unit or even fire or explosion !
5.3. Do not place the appliance on sloping or uneven ground !
5.4. Please always keep a sufficient distance to the wall to avoid possible
overheating of the appliance.
5.5. For an effective and economical heating operation, please close all doors
and windows in the room of the heater !
Technical data
Model designation: WDH-IFH15
Voltage: 400V ~ 50Hz
Max. Power consumption: 15 kW
Connection: 32 A
Heating stages: 3 ( 1 = 5 kW, 2 = 10 kW, 3 = 15 kW )
Thermostat: Stepless adjustment ( 0 ~ 40 °C )
Air flow rate: Approx. 2,245 m3/h
Rated heat output: 15.0 kW
Minimum heat output: 5.0 kW
Max. cont. Heat output: 15.0 kW
Auxiliary power consumption elmax: N/A
Auxiliary power consumption elmin: N/A
Auxiliary power consumption elSB: N/A
Type of temperature control: With mechanical thermostat
Protection class: IPX4
Dimension (H/W/D): 550 x 410 x 360 mm
Weight: 14,5 kg
There may be deviations in the technical data!
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
Other
Warranty statement:
Notwithstanding the statutory warranty claims, the manufacturer grants a warranty in accordance with the laws of
your country, but at least 1 year (in Germany 2 years for private individuals). The warranty begins on the date of
sale of the appliance to the end user.
The warranty only covers defects that are due to material or manufacturing faults.
are.
Warranty repairs may only be carried out by an authorised customer service. To
To make your warranty claim, please enclose the original sales receipt (with date of sale).
Excluded from the guarantee are:
- Normal wear
- Improper applications, such as overloading the appliance or non-approved accessories.
- Damage due to external influences, use of force or foreign objects
- Damage caused by non-observance of the operating instructions, e.g. connection to the wrong mains voltage
or non-observance of the installation instructions.
- Completely or partially dismantled units
Conformity:
The E-Heater has been tested and itself and/or parts thereof have been manufactured under the following (safety)
standards:
Tested by TÜV Rheinland "GS" and of course with CE (LVD + EMC) conformity.
Tested safety according to: EN 60335-2-30:2009+A11
EN 60335-1:2012+A11+A13+A1+A14+A2
EN 62233:2008
CE (LVD) Conformity tested according to: EN 60335-2-30:2009+A11
EN 60335-1:2012+A11+A13+A1+A14+A2
EN 62233:2008
CE (EMC) conformity tested according to: EN 55014-1:2006+A1+A2
EN 55014-2:2015
EN 61000-3-11:2000
EN 61000-3-12:2011
EN 55014-1:2017
Correct disposal of this product:
Within the EU, this symbol indicates that this product should not be disposed of with household waste.
Waste equipment contains valuable recyclable materials that should be recycled and not harm the
environment or human health through uncontrolled waste disposal. Therefore, please dispose of old
appliances via suitable collection systems or send the appliance for disposal to the place where you
purchased it. They will then recycle the appliance.
I wish you much pleasure with this appliance.
Keep these instructions for use in a safe place !
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: Info@Aktobis.de
Notes:
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WDH IFH15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WDH IFH15 in the language / languages: English as an attachment in your email.

The manual is 0.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of WDH IFH15

WDH IFH15 User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info