805499

Watts Climatic Control Heating and Cooling Manual

20
Zoom out
Zoom in
Previous page
1/28
Next page
2P.1: Panel Heaters + water floor
heating and cooling system
2P.1
The second pump for
direct temperature
circuit (panel heater)
will be stopped in
cooling mode.
No cold water in panel
heater!
2P.2: Fan coil units and Water Floor
Heating and Cooling system
2P.2
The second pump is
used to control a fan
coil circuit.
_
_
_
th
5
Thermostat selection menu:
No: Installation without thermostat
Yes: Wired thermostat(s) is installed.
rF: Wireless RF thermostat(s) is in-
stalled.
No
No, Yes, rF
The following parameter is only available if “th” parameter is set to “Yes”
_ _ _ thty
6
Wired thermostat type selection:
Std:
Standard Heat only thermostat
rEv:
Reversible Heat&Cool thermostat
Std
Std, rEv
S
YSTEM PARAMETERS
Value Parameters description
Factory
setting
Alternative
setting
setting
The following parameter is only available “th” parameter is set to “Yes” or “no” and if water sensor is mounted on
the return pipe of the hydraulic circuit.
_
_._
b
AP
7
bGAP Boost function
The incoming water temperature will
be increased by +20%* if the return
temperature is less than calculated
water temperature minus bGAP set-
ting.
Wret < Wcal – bGAP => WCal +20%*
Press on the (OK) to view the instan-
taneous value of the return sensor.
Remark: if no water return sensor is
wired then this boost function is
bypassed.
*Remark2: in Cold mode
Wret > Wcal + bGAP => WCal +20%
10.0°C
1 to 20°C
The following parameter is only available if “th” parameter is set to “rF”
_
_
_
t
F1
8
RADIO-CONFIGURATION with RF thermostat for room temperature (trF1)
1.
Press the (OK) key. Using the (+) or (-) keys to set the Controller into rf init mode.
„INI thrF“ appears on the display.
2.
Set the RF thermostat into rf init mode ( MuB).
3.
If successful rf initialisation the RF thermostat sends a radio signal to the Controller.
The actual value of room temperature appears flashing on the display instead of ”INI”.
4.
The process is completed by pressing the (OK) key of the Controller.
5.
Exit the rf init mode of the RF thermostat. (
MuB).
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Watts Climatic Control Heating and Cooling at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Watts Climatic Control Heating and Cooling in the language / languages: English as an attachment in your email.

The manual is 2.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info