676557

Waterpik WP-560 Manual

6
Zoom out
Zoom in
Previous page
1/68
Next page
6
Charging Unit Prior to First Use
Plug the power cord into the wall and place the magnetic charger on the front
of the unit for approximately 4 hours (see image). The charge indicator on
the handle will flash when charging and will stay on continuously when the
unit is fully charged. A full charge will last for approximately 1 week of typical
use. When the batteries are in need of charging (approximately 30% charge
left) the charge indicator light will blink 8 times quickly after use to indicate
that you should recharge the unit. A complete recharge will take 3-4 hours.
If you use your Water Flosser once a day or less, it is recommended you
charge it once a week. If you use it twice a day or more, charge the unit more
frequently.
Filling the Reservoir
Remove the magnetic charger from the unit prior to filling reservoir and
product use. Lift flip top on reservoir and fill the reservoir with lukewarm
water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle.
Press firmly until the tip clicks into place. To remove the tip from the handle,
press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by pressing the
mode button on the handle. Start with the lowest setting and increase to your
liking.
Recommended Technique
Lean low over sink and place tip in mouth. Aim the tip toward gumline,
and turn the unit ON (I).
For best results, start with the back teeth and work toward the front teeth.
Glide tip along gumline and pause briefly between teeth. Continue until you
have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close
lips to avoid splashing but allow water to flow freely from mouth into
the sink.
Keep unit upright during use for best results.
When Finished
Turn the unit off. Empty any liquid left in the reservoir.
If desired, the reservoir may be removed from the power handle by sliding
the reservoir release latch to the unlock position(1) and then sliding the
reservoir down towards the base of the unit(2).
GETTING STARTED
MODE
HIGH
LOW
MEDIUM
MODE
HIGH
LOW
MEDIUM
1.
2.
MODE
HIGH
LOW
MEDIUM
Eject
Fill
M
O
D
E
H
I
GH
LOW
M
E
D
IU
M
MODE
HIGH
LOW
MEDIUM
Pressure
Setting
Remove
20023378-FAB_WP-560EU_IM_F2.indd 6 5/24/17 7:39 AM
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waterpik WP-560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waterpik WP-560 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 6,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info