Control
Panel
1. Vacuum button with indicator light
Use this button to vacuum and seal a
vacuum bag. The vacuum bag will
automatically be sealed once the air has
been sucked out of the bag. The Vacuum
button light will burn whilst the vacuum
sealing is in progress.
2. Seal button with indicator light
Use this button to only seal a vacuum
bag. There will be no vacuum. This Seal
button light will burn whilst the sealing is
in progress.
3. Cancel button
Pressing this button to cancel an
ongoing vacuum- or sealing process.
4. Gentle button with indicator lights
Use this button before vacuum sealing
fragile food. The light will indicate the
mode setting of the Wartmann
®
vacuum
device. The default setting is “Normal”.
Press the Gentle button one time to
switch to “Gentle”.
5. Moist button with indicator lights
Use this button before vacuum sealing
moist food. The light will indicate the
mode setting of the Wartmann
®
vacuum
device. The default setting is “Dry”.
Press the Moist button one time to
switch to “Moist”.
Using the
Vacuum device
Unpacking the vacuum device
and preparations for rst use
Take the Wartmann
®
vacuum device out of
the box and remove all packaging materials.
Place the Wartmann
®
vacuum device on a
horizontal surface in a location where the
Wartmann
®
vacuum device cannot tip over,
even when passing.
Switching on the vacuum device
Insert the plug of the Wartmann
®
vacuum
device into a wall socket. The Wartmann
®
vacuum device is now ready for use.
Vacuum seal a product in a vacuum bag
Choose a vacuum bag of suitable width,
not wider than 28 cm, and place your
product in the bag, leaving at least 5 cm
open at the top. Open the lid of the
Wartmann
®
vacuum device and place the
open end of the bag over the pressure strip with
the open end inside the vacuum chamber.
Close the lid and press it lightly at both corners until
the Unlock keys are locked in their position. The lid
will be locked at both sites (left and right).
Press the Vacuum button to start the sealing.
The Vacuum indicator light will now switch on
and you will hear the noise of the pump working.
You will see that the air is being sucked out of the
vacuum bag. Once the air is out of the vacuum bag
the vacuum pump stops and the Sealing indicator
light will switch on. Wait until the Sealing indicator
light goes out again.
Now press both Unlock keys and open the lid.
Take your vacuum bag out and carefully inspect
1110
