694502

Wanders S75 Manual

17
Zoom out
Zoom in
Previous page
1/56
Next page
17
GB
easily using a slightly moist cloth once the stove has cooled. If necessary, use a special cleaning agent designed
for ceramic hobs. Do not touch the clean glass with your ngers. Fingerprints burn into the glass and can never
be removed.
After the rst couple of times using the stove, the cord in the door will expand to follow the contours of the stove.
HI2 Insides
The HI2 insides were specially developed for WFS and, without giving away too much of our
secret recipe, comprise a mix of special concrete with vermiculite. The heat-reective action
of the vermiculite generates heat build-up in the combustion chamber while the rest of the
material stores the heat.
Once combustion is well under way, you will see a perfect re – clean, eco-friendly combustion
with a high heat yield.
The re bricks, weighing in at some 30 kg, initially require thorough heating. The heat in the combustion chamber
is key to ensuring the stove works properly. We therefore advise getting the re going with thinner, more easily
combustible wood. Leave the doors slightly ajar for a quarter of an hour so the re quickly starts to burn ercely.
If you then ensure a red-hot bed of ash for further combustion, this will create decent ames and radiant heat that
you can enjoy for the rest of the evening, while occasionally adding fresh wood.
The heat is stored by the re bricks - known as accumulation - so any fresh logs ignite quickly. This accumulating
action means that the stove continues to give o heat for a long time after the re is extinguished.
The HI2 insides are made using water, so the moisture will have to be heated out of the re bricks during the rst
few sessions.
Our advice is to get a really good re going for the rst few hours. At that point, the re will probably not look like
it did in the showroom, but the appearance will improve rapidly after the rst couple of res.
After installation, it is essential that you rst allow your home to dry thoroughly. Inadequately
dried walls retain soot and other substances that are released by the stove during use. The risk
of cracks in the plaster is also highest at that point.
Fuel
The S60/S75 only burns on wood. Never place more than 2 kg (S 60) and 3 kg (S 75) of fuel in the re at once.
Always use clean, harvested timber that has been allowed to dry thoroughly. See the table below for drying times.
Moist wood burns poorly and generates far too much smoke. This can cover the glass of your stove with black
soot. Soot particles (creosote) also stick in your ue, which increases the risk of a chimney re.
Fresh, moist wood contains about 50% moisture. Cleaved wood still contains 20% moisture after drying it for a year
and moisture percentage will be decreased to 12 to 15% after drying it for two years. Dry wood gives nice ames
and little or no smoke, and the re will crackle when burning. Wet wood makes a hissing sound, gives much smoke
and only small ames which will considerably dampen the pleasure of burning your stove and the heat output.
Wood Drying time
Fir, Poplar 1 year
Lime, Willow, Spruce, Birch, Ash, Alder 1,5 years
Fruit trees, Beech 2 years
Elm 2,5 years
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders S75 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders S75 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info