Manual Wanders S60 (page 22 of 56) (English, German, Dutch, French)

694501

Zoom out

Zoom in

1/56

Ventilation in the hearth

We advise adding ventilation to the hearth where possible. These ventilation holes, both above and below the

stove, must be at least 400 cm2 in size. Do not t the upper ventilation grills too close to the ceiling.

The chimney ue

Before placing the stove you must observe the following points:

• If the stove is connected to an existing chimney, you must rst have the chimney professionally cleaned and

checked by a qualied chimney sweep company. Any cut-o valves or stop valves must be removed.

• The ue tube of the stove must be connected with the chimney without diversions.

• The underpressure in the chimney must be at least 12 Pa or 0.12 mbar.

• The chimney ue must always end up in

outlet area 1 (see the drawing and the table

below)

• At the time of placing the stove, the chimney

ue must be clean, leak-proof and without

obstructions, and must have a diameter of

150 mm.

• Any bends in the ue tube must not exceed

45 degrees.

• Ensure that the chimney tube can discharge

the ue gases adequately, properly and

safely.

Fire Safety

For reasons of re safety is it important to observe the instructions below before installing the stove.

1. If the oor around the stove is made of combustible material, you must use a oor slab. The oor slab must

measure at least: - 50 cm from the stove on the front side of the door - 30 cm from the stove on the sides of

the door.

2. Keep at least a distance of 80 cm between the stove and combustible objects such as curtains, wooden

objects (cupboards and paintings) and glass objects. Keep the same distance from the ue tube.

3. Wooden construction parts within the radiation range of the stove (80 cm from the exterior of the stove) must

be covered with reproof material.

4. If the ue tube goes through a ceiling and/or roof that consist of ammable materials, the ceiling and the roof

must be covered with reproof materials all around (about 80 cm). Pay also attention to joisted oor layers

and any electric wiring.

5. Keep a distance of at least 50 cm (in all directions) between the stove and supporting steel construction parts.

6. Shield o all combustible materials within a radius of 80 cm from the stove openings with non-combustible

materials.

7. Never cover the chimney breast with combustible material (e.g. paper covering).

8. The wall behind the stove must be made of reproof materials or be insulated. The insulation material must be

able to withstand temperatures of 700 degrees Celsius and have a density of at least 80 kg/m3.

Installation

The S60/S75 is approved in accordance with the international standard EN 13229 and has an extra supplementary

standard for optimal environmentally friendly combustion in relation to ue gases (art. 15a B-Vg. Des BmfWA). The

stove can be connected to a ue to which several other stoves are connected. The pipe for ue gas extraction has

a diameter of 150 millimetres (connection 146 mm external).

Combustion air supply

The stove must have an adequate combustion air supply. If necessary, create an extra air supply as close as possible

to the stove, as this prevents draughts. The air supply in the room should be at least 150 cm2 in size. An extra air

supply is absolutely necessary if:

• The dwelling is tted with a heat-recovery system.

• The dwelling has a central vacuum system.

• There is an extractor hood in the same room.

3 3

A X

X > 23˚

X < 23˚

500 mm

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Wanders S60 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Wanders S60 Manual

Product: