Manual Wanders Peppel (page 19 of 48) (English, German, Dutch, French)

694508

Zoom out

Zoom in

1/48

General instructions

The Peppel is tested in accordance with the international EN 13240 standardization, and has an extra additional standardization

for optimally environment-friendly heating devices related to ue gases. The stove can be connected to a ue tube to which

several stoves are connected. The ue tube has a diameter of 150 millimetres.

The heating device must be placed by an acknowledged installer and according to the installation instructions

given below. The national and local rules and regulations for placing and using wood-burning stoves are equally

applicable. WANDERS does not give any guarantee if the Peppel is connected or installed incompletely or

incorrectly.

It is not allowed to place the stove in:

• Arcades and corridors accessible to the public.

• Stairwells, except in buildings with no more than 2 dwellings.

• Spaces where highly ammable or explosive materials are used.

• Spaces where an exhaust system is used or where a mechanical exhaust system is placed, except when the air supply is

taken directly from outside to assure a hazardless combustion.

Preparation

The chimney ue

Before placing the stove you must observe the following points:

• If the stove is connected to an existing chimney, you must rst have the chimney professionally cleaned and checked by

a qualied chimney sweep company. Any cut-o valves or stop valves must be removed.

• The ue tube of the stove must be connected with the chimney without diversions.

• The underpressure in the chimney must be at least 12 Pa or 0.12 mbar.

• The chimney ue must always end up in outlet

area 1 (see drawing)

• At the time of placing the stove, the chimney

ue must be clean, leak-proof and without

obstructions, and must have a diameter of 150

mm.

• Any bends in the ue tube must not exceed 45

degrees.

• Ensure that the chimney tube can discharge the

ue gases adequately, properly and safely.

• The values for calculating the chimney tube is

given in the section on Technical Information,

page 46.

Fire Safety

For reasons of re safety is it important to observe the instructions below before installing the stove.

1. If the oor around the stove is made of combustible material, you must use a oor slab. The oor slab must measure at

least:

- 50 cm from the stove on the front side of the door

- 30 cm from the stove on the sides of the door.

2. Keep at least a distance of 100 cm between the stove and combustible objects such as curtains, wooden objects

(cupboards and paintings) and glass objects. Keep the same distance from the ue tube.

3. Wooden construction parts within the radiation range of the stove (80 cm from the exterior of the stove) must be covered

with reproof material.

4. If the ue tube goes through a ceiling and/or roof that consist of ammable materials, the ceiling and the roof must be

covered with reproof materials all around (about 80 cm). Pay also attention to joisted oor layers and any electric wiring.

5. Keep a distance of at least 50 cm (in all directions) between the stove and supporting steel construction parts.

3 3

A X

X > 23˚

X < 23˚

500 mm

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Peppel in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,72 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Wanders Peppel Manual

Product: