571832

Wanders Norma Free Manual

18
Zoom out
Zoom in
Previous page
1/65
Next page
18
Installation
It is common practice for the dealer where you
purchased your gas unit to take also care of installing
it and connecting it to the mains. If this is not the case,
please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons
is prohibited, in which case we cannot give any guarantee
that your gas hearth is functioning properly.
Ready for use
After connecting your Wanders gas unit to the mains and
making the necessary adjustments, the hearth is ready
for use. The pilot flame must be ignited manually.
Receiver and gas governor (A)
Lighting the pilot flame manually
Open the flap at the bottom of the hearth. Check whether
the gas tap is turned on. You will see the control buttons
of the hearth in the middle behind the flap.
1. Turn the ignition knob (A) clockwise until it stops,
then press the knob and wait a few seconds.
2. While keeping the knob pressed, turn the knob to
the left until you hear a click.
3. Look through the glass pane to see whether the pilot
flame at the left of the hearth is burning. If the pilot
flame is not ignited, repeat steps 2 and 3.
4. If the pilot flame is burning, keep the ignition knob
pressed for some time. When you release the knob
after 30 seconds, the pilot flame must stay alight. If
it doesn’t, wait for 5 minutes before trying to light
the pilot flame again.
5. If the pilot flame stays alight, turn the knob anti-
clockwise till the symbol of the large flame. Now
you can close the flap and regulate the height of the
flames with the remote handset.
Child-proof safety lock
If you turn the ignition knob to the symbol of the
small flame, the remote control is put out of action
while the pilot flame will stay alight.
Arranging the height of the flames
Point the remote control handset towards the gas unit.
The hearth will burn higher when pressing the Ÿ button.
The hearth will burn slower when pressing the ź button.
When you keep pressing the ź the hearth will switch to
the pilot flame position. You can also put the hearth on
the pilot flame position manually by turning the ignition
knob (A) clockwise until the minimum is reached.
When you press both buttons, you will see the ‘transmit’
signal top left on the display. The hearth has reached its
highest or lowest position when the LED of the receiver
starts blinking.
Switching off the pilot flame
The pilot flame is switched off manually. Open the
flap, gently press the ignition knob (A) and then turn it
clockwise.
Lighting the hearth for the first time
When you light your gas unit for the first time, the hearth
must ‘anneal’.The unit has a heat resistant lacquer which
must still burn in. Though this may give an unpleasant
smell, it is otherwise harmless. It is advisable to turn onto
high for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
After lighting your heath the walls, ceilings and grates
may show some discolouration.This is caused by the
dust particles that burn in the convection cover. This
is a natural process for which WANDERS can not
be held responsible. To minimize the discolouring
we refer to the advice given for atmospheric hearths.
Your installer can give you more information about
this.
Some deposit may form on the ceramic glass of the door
of the hearth. You can easily remove this deposit with
a damp cloth and if necessary some cleansing agent
for ceramic rings when the glass has cooled down. You
can open the door of the hearth by turning the screw
clockwise at the bottom. You can use a coin for this.
Photograph: Remove ornamental frame
• Unscrew the two cross-slotted screws and lift the glass
pane.
• PLEASE NOTE: Be sure not to touch the cleaned glass
with your fingers when you replace the pane. Finger
marks burn in the glass.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Norma Free at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Norma Free in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info