533287

Wanders Luna Manual

19
Zoom out
Zoom in
Previous page
1/56
Next page
18
manual operation after some time
Setting the desired temperature
Press and hold the AUTO button until the TEMP indication
blinks. You can set a higher temperature with the ▲
button and a lower temperature with the ▼ button. Then
wait a few seconds, or press the AUTO button to switch
to the automatic modus.
Checking the set temperature
Briefly press the AUTO button. The display briefly shows
the preset temperature and then displays the room
temperature.
TIMER
You can preset a total of four time-settings. When you
link up all four time-settings, you can be sure of a
comfortable room temperature at all times.
Press and hold the TIMER button until the indication
P1<☼> blinks. With the ▲ and ▼ buttons you can
set respectively the hours and the minutes. By briefly
pressing the TIMER button you can browse through the
timer programme P1<☼>, P1<>, P2<☼> and P2<>.
Here is an example of a possible presetting.
P1<☼>-temp: 07:30 - 08:30 the preset temperature
P1<>-temp: 08:30 - 17:00 off
P2<☼>-temp: 17:00 - 23:00 the preset temperature
P2<>-temp: 23:00 - 07:30 off
The TIMER function works only when the pilot flame is
on. If the TIMER mode is switched on, the temperature
control will be the same as in the AUTO position. You
can switch off the TIMER mode with the ▲ and ▼
buttons. The remote control will automatically switch to
the MAN function.
MAN
When the display shows the MAN position you can
manually turn the hearth higher ▲ and lower ▼ by
using the big buttons. When you press and hold the ▼
button the hearth will go to its lowest position: the pilot
flame. When you keep these buttons pressed, you will
see the ‘transmit’ symbol top left in the display. You will
know when the hearth has reached its highest or lowest
position when the LED of the receiver starts blinking.
Placing the ceramic lumber set
To place the ceramic logs you must open the door of the
heart by turning the screw at the bottom clockwise with
a coin.
• Fill the bottom of the burner with the supplied granules.
Never use more than the quantity of granules supplied
with the hearth.
• Please make sure that you place the ceramic logs
exactly as shown in the illustrations and in the
especially designed recesses of the lower logs. Always
place the logs with the sharp or round edges pointing
downwards to avoid covering the flames. This will
give flames that burn well and evenly and prevents
soot deposit.
• PLEASE NOTE: Do not touch the glass with your
fingers when closing the door of the gas unit. Finger
marks will burn in and leave stains.
• Firmly close the door and replace the side compartment
before lighting the hearth.
Step 1
Step 2
Step 3
Do not place a log in front of the pilot flame as this will
prevent the main burner from igniting and may result in
the accumulation of unburned gases in the hearth. If this
happens you must extinguish the pilot flame and wait for
5 minutes before lighting the hearth again.
It is prohibited to add extra ceramic logs or other materials
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Luna at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Luna in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info