571826
7
Zoom out
Zoom in
Previous page
1/36
Next page
installation, servicing and user instructions manual | GB + IE
7
Simultaneously press and hold buttons B & C (Star and Large Flame), until a short acoustic beep conrms the
start sequence has begun; release the buttons.
Continuing signals conrm the ignition is in process.
Once pilot ignition is conrmed, there will be gas ow and the main burner will ignite.
Repeat process if pilot ignition fails.
2.7 To Turn the appliance OFF
Press the OFF button (Button B g. 1.1) on the Handset. This will extinguish all Burners including Pilot.
Note: - Repeated presses of the small ame (Button D g. 1.1) will turn the main burner OFF, but will leave the Pilot
alight.
2.8 Adjusting the Flame setting
To increase the ame height; press the large ame button (Button C g. 1.1).
To decrease the ame height; press the small ame button (Button D g. 1.1).
2.9 Using the "Eect" Burner
Note: The solenoid valve will not operate for one minute after Ignition.
The solenoid valve cannot be operated manually. If the battery runs down, the solenoid will remain in its
last operating position.
During normal operation the solenoid will be reset to the ON (Open) when the Gas Valve is switched OFF
via the Handset.
Upon ignition both "Main" and "Eect" burner are ON.
To switch the "Eect" burner OFF, simultaneously press the OFF and Large Flame buttons (buttons B & C g. 1.1).
To switch the "Eect" burner ON, simultaneously press the SET and Large Flame buttons (buttons A & C g. 1.1).
Printed instructions are located on the battery cover on the rear of the handset.
2.10 Setting °C/24 hour or °F/12 hour clock
Simultaneously press OFF and Small Flame buttons (buttons B & D g. 1.1) until display changes from Fahrenheit/12
hour clock to Celsius/24 hour clock and vice versa.
2.11 Setting the Time
The display will ash after either:
Installing the battery or
Simultaneously pressing the Large Flame Button and Small Flame Button (buttons C & D g. 1.1)
Press the Large Flame button (button C g. 1.1) to set the hour.
Press the Small Flame button (button D g. 1.1) to set the minutes.
Press OFF (button B g. 1.1) to return to standard operating mode or simply wait and it will return to standard
mode after approximately 15 seconds.
2.12 Cleaning and Maintenance
This appliance should be inspected and serviced once a year by a qualied, competent and registered person.
The inspection and maintenance must at least ensure that the appliance is working correctly and safely. It is
advisable to clean the appliance of any dust and debris before regularly during the heating season and especially
if the appliance has not been used for some time. This can be done with a soft brush and a vacuum cleaner or a
damp cloth and if required a non-abrasive cleaning agent. Do not use corrosive or abrasive substances to clean
the appliance.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Danta 800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Danta 800 in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wanders Danta 800

Wanders Danta 800 User Manual - German - 28 pages

Wanders Danta 800 Usermanual and installation guide - Dutch - 28 pages

Wanders Danta 800 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info