802057
26
Zoom out
Zoom in
Previous page
1/32
Next page
26
De master-lader detecteert de energiemeter niet
De master-lader detecteert automatisch de energiemeter als beide apparaten correct zijn
aangesloten en ingeschakeld. Wanneer de communicatie met de energiemeter is vastgesteld, wordt
een bliksempictogram weergegeven op het scherm van Commander, Commander 2 en Copper,
en wordt er een “RxTx”-pictogram weergegeven op het scherm van de stroommeters EM112 en EM340.
Controleer of de RS485-kabel goed is aangesloten op beide apparaten volgens de indicaties in
bijlage A.
Controleer of de RS485-schakelaar op de master zit als het een Pulsar plus of Commander 2 is.
Onregelmatig gedrag
Slecht contact op de communicatiekabels. Controleer of alle CAN-communicatiekabels goed
zijn aangesloten op de laders en dat de RS485-communicatiekabel goed is aangesloten tussen
de master en de energiemeter.
Verkeerde configuratie op de master.
Verkeerde weerstandswaarde tussen communicatielijnen. Schakel alle laders uit en meet de
Ohm-weerstand tussen CAN-H en CAN-L, het moet ongeveer 60 Ohm zijn. Zo niet, controleer
dan opnieuw sectie 2.
Lader blijft wachten op stroom, ook al is er geen andere auto
De stroomtoewijzing kan tot 30 seconden duren.
Zorg ervoor dat er geen schema's zijn geprogrammeerd.
Controleer of de master en de slaves allemaal zijn gekoppeld. Indien niet de maximale stroom,
wordt per fase met 6 A per niet gekoppelde lader verminderd.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wallbox Dynamic Power Sharing at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wallbox Dynamic Power Sharing in the language / languages: Dutch as an attachment in your email.

The manual is 5.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info