639103
49
Zoom out
Zoom in
Previous page
1/464
Next page
MCA1215 – MCA2440 Installing the device
49
5: U phase (float)
After the U0 phase, the battery charger switches to conservation charging
function (U phase).
If DC loads are connected, they are powered by the device. Only if the power
required exceeds the capacity of the device is this surplus power provided by
the battery. The battery is then discharged until the device re-enters the I
phase and charges the battery.
6: 12-day conditioning
Every 12 days, the battery charger switches back to phase 1 for 85 min in
order to revive the battery. This prevents any fatigue symptoms such as
sulphation.
7 Installing the device
When selecting the installation location, observe the following instructions:
The device can be installed horizontally or vertically.
Do not install the device
In wet or damp environments
In dusty environments
In the vicinity of combustible materials
In areas where there is a danger of explosions.
The place of installation must be well ventilated. A ventilation system must
be available for installations in small, enclosed spaces. The clearance
around the device must be at least 25 cm.
The air inlet on the underside and the air outlet on the back of the device
must remain clear.
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can
lead to reduced output.
The device must be installed on a level and sufficiently sturdy surface.
Do not install the device in the same area as the batteries.
Do not install the device above batteries, because they can emit corrosive
sulphur fumes that will damage the device.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waeco PerfectCharge MCA2440 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waeco PerfectCharge MCA2440 in the language / languages: All languages as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info