654000
23
Zoom out
Zoom in
Previous page
1/34
Next page
SinePower Wechselrichter anschließen
23
10.2 Wechselrichter an Batterie anschließen
a
Warnung!
Achten Sie darauf, dass die Polarität nicht vertauscht wird. Bei Ver-
polung der Batterieanschlüsse entsteht ein großer Funkenschlag
und die internen Sicherungen brennen durch. Der Austausch der
Sicherungen darf nur durch eine Fachkraft erfolgen!
I
Hinweis!
Ziehen Sie die Schrauben an den Anschlussklemmen mit einem
Drehmoment von 12 – 13 Nm fest. Lose Verbindungen können zu
Überhitzungen führen.
Stellen Sie den Hauptschalter (Abb. 2 1, Seite 4) auf „Off“.
Schrauben Sie die vier Befestigungsschrauben (Abb. 8 2, Seite 7) der
Rückwand des Gerätes mit dem beiliegenden Innensechskant-Schlüssel
heraus.
Nehmen Sie die Rückwand (Abb. 8 1, Seite 7) ab.
Schieben Sie das Plus-Kabel durch die Öffnung „POS (+)“ und das
Minus-Kabel durch die Öffnung „NEG (–)“ in der Rückwand.
Drehen Sie die Sicherungsschraube (Abb. 8 3, Seite 7) etwas heraus.
Schieben Sie den Kabelschuh (Abb. 8 5, Seite 7) des Plus-Kabels
zwischen den Federring (Abb. 8 4, Seite 7) und die Plus-Klemme
(Abb. 3 6, Seite 4).
Gerät
erforderlicher
Kabelquerschnitt
Kabelsicherung
MSP 702 25 mm² 100 A
MSP 704 15 mm² 50 A
MSP 1012 35 mm² 200 A
MSP 1024 25 mm² 100 A
MSP 1512 35 mm² 200 A
MSP 1524 25 mm² 100 A
MSP 2012 70 mm² 250 A
MSP 2024 55 mm² 150 A
MSP 2512 95 mm² 400 A
MSP 2524 70 mm² 200 A
_MSP702_MSP2524.book Seite 23 Freitag, 5. September 2008 3:36 15
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waeco MSP 2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waeco MSP 2012 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info