671862
29
Zoom out
Zoom in
Previous page
1/68
Next page
EN
CoolMatic MR07, MRR07, MH07 Installing and connecting the device
29
6.2 Installing the device
Observe the following installation instructions for the place of installation:
Avoid placing the device next to heat sources such as heaters, gas
ovens, hot water pipes, etc.
Install the device in a dry, sheltered place.
The device must be installed so that heated air from it can dissipate
easily. Therefore make sure there is adequate ventilation (fig. 4,
page 4).
Fix the device with eight screws (fig. 5 1, page 4).
6.3 Removing the transport protection
The device has a locking mechanism to protect it during transport. The fol-
lowing settings are possible (fig. 6, page 5):
Position 1 (transport lock): (1). The door is locked and secured. To open
the door, turn the bolt to position 2.
Position 2: (2). The door can be opened.
Position 3 (“VENT” position): (3). The door is slightly open, but fixed in
position. Use this position, for example, if you are not going to use the
device for a long time.
6.4 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (fig. 7, page 5):
Remove the upper door hinge (1).
Carefully lift out the door.
Remove the threaded pins (2).
No. in fig. 4,
page 4
Explanation
1 Hot waste air
2 Cold intake air
3 Condenser
4 With decorative panel 50 mm space at the top!
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waeco CoolMatic MRR07 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waeco CoolMatic MRR07 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info