639022
36
Zoom out
Zoom in
Previous page
1/352
Next page
EN
Installing and connecting the refrigerator CD50, CRD50
36
7.1 Installing the refrigerator
A
The appliance is designed for ambient temperatures between +16 °C and
+38 °C. In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens, hot water pipes etc.
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides). Therefore make sure there is adequate
ventilation (fig. 3, page 4).
The condensation which forms during normal operation of the refrigerator
can be drained off via two outlets on the appliance. For delivery purposes,
these outlets are sealed. The two outlets are located on the rear and on the
underside of the appliance (fig. 4, page 4).
Choose the condensation outlet most suitable for the place of installation
and remove its cap.
Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
NOTICE!
Fasten the device as described in the operating manual to
prevent hazards.
Keep objects clear of openings in the housing or mounting
structure (such as ventilation slots).
The refrigerator is only suitable for installation in a fitted niche.
Once it is installed, only the front of the appliance may be
accessible.
If brakes are applied fully, then strong forces act in the direc-
tion of travel. In order to prevent damage to the cooling appli-
ance and the vehicle interior, the cooling appliance should not
be installed with the front facing the direction of travel.
No. in
fig. 3, page 4
Explanation
1 Cold intake air
2 Hot waste air
3 Condenser
4 Spacing above the fridge if insufficient air can circulate above
or at the side.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waeco COOLMATIC CRD 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waeco COOLMATIC CRD 50 in the language / languages: All languages as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info