639031
23
Zoom out
Zoom in
Previous page
1/216
Next page
EN
CD20, CD30 Installation
23
6 Installation
A
I
Please observe the following instructions:
Determine the necessary cable cross section of the intake line using the
diagram below:
Connect your cooling device as directly as possible to the battery terminal
or to an outlet with a fuse of at least 15 A (12 V) or 7.5 A (24 V).
To screw the device in place use the screwing holes provided on the side
of the device (see fig. 4, page 4 and fig. 5, page 4).
You can detach the compressor from the cooling device and mount it in
another place on the cooling device, or separately from it (fig. 2,
page 3). Make sure that the refrigerant line is 1.5 m (CD20)/1.5 m (CD30)
long.
NOTICE!
Ensure that the positive cable is connected to the positive ter-
minal and the negative cable to the negative terminal.
When choosing the installation location, ensure that the air
heated by the liquefier can be drawn off.
NOTE
To avoid voltage loss and therefore a drop in performance, the
cable route should be kept as short as possible and should not
be interrupted if this is possible. For this reason avoid additional
switches, plug or power strips.
0262422201816141210862842
0
14
12
10
8
6
4
2
16
24 Volt devices
12 Volt devices
Cable cross section (mm²)
Metres of cable (m)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Waeco COOLMATIC CD 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Waeco COOLMATIC CD 30 in the language / languages: All languages as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info