513128
35
Zoom out
Zoom in
Previous page
1/55
Next page
TROUBLESHOOTING
Page 35
INDEX
CONTENTS
Testing your tablet
Make sure your computer is turned on, the operating system has finished loading, and the tablet is properly
connected to an active USB port. Then try the following tests:
1. Check the tablet. The tablet’s orange status LED will light whenever the tablet is properly connected and your
computer has registered it as a USB device. If the LED is on, continue with step 2.
If the status LED does not glow then the computer is on and the system has fully loaded, then:
Make sure the tablet USB cable is securely connected to an active USB port on your computer.
If you are connecting the tablet to a USB hub (or hub device such as a keyboard with USB ports), be sure
the USB hub is properly connected to your computer and is active.
Connect the tablet into a different USB port or try connecting to the USB port on another computer.
If the tablet’s status LED does not illuminate after your computer is on and has finished booting up, your USB
port may be disabled. It may be necessary to check your system BIOS setting to verify that you have connected
the tablet to an active USB port.
2. Check the pen.
Move your pen across the active area of the tablet; the screen cursor should move in the corresponding
direction on your monitor or display screen.
Press the pen tip against the tablet surface. The status LED on the tablet should turn from orange to green.
Next, without applying pressure to the pen tip, hold the pen tip within 5 mm (0.20 inch) of the tablet surface
and press the upper side switch. The status LED should again change from orange to green.
Then, without applying pressure to the pen tip and while holding the pen tip within 5 mm (0.20 inch) of the
tablet surface, press the lower side switch. The status LED should change from orange to green.
If these tests fail, you may have a defective pen or tablet. See t
echnical support options.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wacom Penpartner 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wacom Penpartner 2 in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wacom Penpartner 2

Wacom Penpartner 2 User Manual - German - 56 pages

Wacom Penpartner 2 User Manual - Dutch - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info