1. Clip the receiver to the top center of a single or notepad sheet of paper.
2. Using the provided USB cable, properly connect the receiver to a
primary USB port located directly on your computer, or to a powered
USB hub.
If an autorun dialog opens, dismiss the dialog.
3. Hover the Inkling digital pen slightly over the paper to navigate your
computer. (If the pen is in sleep mode, first touch the pen tip to the
paper. This synchronizes the pen to the receiver.)
• Tap once to click.
• Tap twice to double-click.
4. When finished, disconnect the receiver from your computer. Before
disconnecting, use the S
AFELY REMOVE HARDWARE (Windows) or EJECT
(Macintosh) system option. The receiver turns off automatically when
disconnected.
The active area beneath the receiver senses pen movement. This area is
12 x 19 cm (4.8 x 7.6 inches), and begins approximately 5 cm (2 inches)
below the receiver. You can only navigate when using the pen within the
receiver’s active area.
Tip
: Leaving the Inkling digital pen within the receiver active area may
interfere with screen cursor positioning when using other pointing devices,
or may prevent your computer from going to sleep.
The cursor on your monitor or display screen
follows as you move the pen tip.
