513125
62
Zoom out
Zoom in
Previous page
1/85
Next page
62
62
Interactive pen display
Contents Index
Index
Contents
You notice a delay at the
beginning of pen or inking
strokes.
Open the Wacom tablet control panel and go to the PEN tab.
Try decreasing the T
IP DOUBLE CLICK DISTANCE. If that does not work,
move the T
IP DOUBLE CLICK DISTANCE slider to the OFF position in order
to turn off double-click assist.
You have to press hard with
the pen when clicking or
writing.
Open the Wacom tablet control panel and go to the P
EN tab.
Move the T
IP FEEL slider toward SOFT, or select the DETAILS... button
and decrease the S
ENSITIVITY and CLICK THRESHOLD settings.
The pen tip does not function. Be sure you are using the pen that originally came with your interactive
pen display. Other pens may not function properly on the pen display.
Check the control panel’s P
EN tab and verify that a CLICK function is
assigned to the pen tip.
Make sure the status LED lights blue when the tip is pressed. If the
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.
If the LED still does not light, you may have defective hardware (see
Troubleshooting
).
The pen tip and screen cursor
do not properly line up.
Open the Wacom tablet control panel and select the C
ALIBRATE tab.
Continue with Calibrating the pen display
.
Changing the function settings
for the pen has no effect.
Make sure you change the settings for the pen and application that you
are using. See Application-specific settings
.
The pen side switch does not
work.
Be sure you are using the pen that originally came with your pen
display. Other pens may not function properly on the pen display.
Be sure to press the side switch when the pen tip is within 5 mm
(0.2 inch) of the pen display active area. Do this without pressing down
on the pen tip.
In the Wacom tablet control panel, verify that the side switch is set to
the proper function you are expecting to occur for the application and
tool you are using.
Check also the S
IDE SWITCH MODE. If CLICK & TAP is selected, you will
need to first press the side switch then touch the pen tip to the pen
display screen surface in order to perform a click function.
Make sure the status LED lights blue when you press the side switch.
If not, verify that the USB cable is plugged into an active USB port on
your computer or on a USB hub; the LED will not light if the USB cable
is not plugged into an active port.
If the LED does not light, you may have defective hardware (see
Troubleshooting
).
The screen cursor moves but
it does not jump to the pen tip
location when the pen is
placed on the display screen,
and it does not follow the pen
tip when the pen is moved
across the display.
Make sure the Wacom driver has loaded properly by opening the
Wacom tablet control panel. If the driver did not load you will see an
error message. If an error message appears, reboot your computer.
If the problem persists, refer to the Installation
instructions and reinstall
the Wacom driver software. (For Macintosh, you must restart your
computer after installing the Wacom driver for proper operation.)
If you have customized the side switch on your pen to toggle between
pen mode and mouse mode, make sure that your pen display is
operating in pen mode.
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wacom DTH2242 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wacom DTH2242 in the language / languages: English as an attachment in your email.

The manual is 4,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wacom DTH2242

Wacom DTH2242 Additional guide - German - 24 pages

Wacom DTH2242 User Manual - German - 85 pages

Wacom DTH2242 Additional guide - Dutch - 24 pages

Wacom DTH2242 User Manual - Dutch - 85 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info