15
Nadel auswechseln
Vorsicht
• Bevor die Nadel ausgewechselt wird, die Maschine unbedingt am Netzschalter ausschalten („ 0 “).
Wird bei eingeschalteter Maschine versehentlich der Fußanlasser gedrückt, läuft die Maschine an
und es kann zu schweren Verletzungen kommen.
• Nur Nadeln des Systems 130/705 H benutzen.
• Zum Nähen keine verbogenen Nadeln verwenden (Verletzungsgefahr).
Überprüfen der Nadel
Um die Nadel zu überprüfen, diese mit der flachen
Seite auf eine plane Oberfläche legen. Die Nadel
von oben und an allen Seiten überprüfen.
Verbogene Nadeln dürfen keinesfalls verwendet
werden!
Einsetzen der Nadel
1. Am Handrad drehen (entgegen dem Uhr-
zeigersinn), bis die Nadel in der höchsten
Position ist.
2. Die Maschine am Netzschalter ausschalten.
3. Den Nähfußhebel senken.
4. Die Schraube lockern und die Nadel nach
unten heraus ziehen.
5. Die Nadel mit der flachen Seite nach hinten,
bis zum Anschlag hoch schieben. Die
Schraube wieder fest ziehen (z.B. mit einer
Münze) und durch Drehen des Handrades
überprüfen, ob die Nadel richtig eingesetzt
wurde.
Hinweis
Die Schraube nicht mit zu großer Kraft anziehen,
sie könnte dadurch Schaden nehmen und sich
wiederum nur mit Gewalt lösen lassen.
Vorsicht
Wurde die Nadel nicht richtig eingesetzt oder die
Schraube nicht fest genug angezogen, kann die
Nadel abbrechen oder die Maschine beschädigt
werden. Es besteht Verletzungsgefahr.
Nadelanschlag
Nadelkanal
Schraube
Flache Seite der Nadel
Paralleler Abstand
die Nadel auf eine plane Oberfläche legen
(Stichplatte, Glas, etc.)
Auch die Nadelspitze auf
Beschädigungen kontrollieren
Nadel
Nadel
031811-GAL1-NMJanome1233.pmd 12.12.2005, 09:3315