12
Auswechseln des Nähfußes
1. Die Maschine am Netzschalter ausschalten.
2. Am Handrad drehen, bis die Nadel in der
höchsten Position ist.
3. Den Nähfußhebel nach oben stellen. Für ver-
schiedene Nähfüße kann der Nähfußhalter
zusätzlich angehoben werden.
Der Nähfußhebel rastet in der höchsten
Stellung
nicht ein, deshalb muss er in dieser
Stellung gehalten werden.
4. Um den Nähfuß vom Nähfußhalter zu lösen,
den kleinen Hebel
auf der Rückseite des
Nähfußhalters drücken.
5. Den anderen Nähfuß so unter dem Nähfuß-
halter platzieren, dass der Nähfußstift
auf
die Aussparung
im Nähfußhalter aus-
gerichtet ist.
6. Den Nähfußhebel nach unten stellen, damit
der Nähfußstift in die Aussparung einrasten
kann.
Sollte der Nähfußstift nicht einrasten, den
kleinen Hebel am Nähfußhalter kurz drücken.
7. Durch Anheben des Nähfußhebels prüfen, ob
der Nähfuß richtig eingerastet ist.
Vorsicht
• Die Maschine am Netzschalter ausschalten, bevor der Nähfuß ausgewechselt wird.
• Immer den richtigen Nähfuß für das jeweilige Stichmuster verwenden! Wird ein falscher Nähfuß
benutzt, kann die Nadel auf den Nähfuß treffen und sich dadurch verbiegen oder abbrechen.
• Nur die beiliegenden Nähfüße verwenden. Die Verwendung anderer Nähfüße kann Unfälle,
Verletzungen und Sachschäden zur Folge haben.
Nähfußhebel: in höchster Stellung
Nähfußhebel (eingerastet)
Hebel am Nähfußhalter
Nähfußhalter
Nähfuß auswechseln
Aussparung im Nähfußhalter
Nähfußstift
031811-GAL1-NMJanome1233.pmd 12.12.2005, 09:3312