Manual VTech Switch and Go Dinos - Dino Launcher 2-in-1 (page 14 of 15) (English)

809964

Zoom out

Zoom in

1/15

Instruction Manual

Launch Button

Auto-Switch Button

Talk Button

LED Light

Fireball Button

Off/Low/High

Volume Switch

INTRODUCTION

Switch into fun with Switch & Go Dinos® Dino Launcher 2-In-1!

Combine these two daring prehistoric creatures to form a mega car!

Launch the two reball projectiles, then launch the race car and watch it

switch into a super Spinosaurus as it rockets forward.

INCLUDED IN THE PACKAGE

• One Switch & Go Dinos® Dino Launcher 2-in-1

• One Quick Start Guide

WARNING

All packing materials such as tape, plastic sheets, packaging locks,

removable tags, cable ties, cords and packaging screws are not part

of this toy, and should be discarded for your child’s safety.

NOTE

Please save this Instruction Manual as it contains important information.

WARNING

Do not aim at eyes or face.

WARNING

Do not discharge any object other than the projectile provided with this toy.

INSTRUCTIONS

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Find the battery cover located on the bottom of the unit, use a

screwdriver to loosen the screw, and then open the battery cover.

3. Remove the old battery by

pulling up on one end of the

battery.

4. Install 1 new AAA (LR03/

AM-4) battery following the

diagram inside the battery

box. (For best performance,

alkaline batteries or fully Ni-MH

charged rechargeable batteries

are recommended).

5. Replace the battery cover and

tighten the screw to secure.

WARNING:

Adult assembly required for battery installation.

Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable

batteries.

• Only batteries of the same or equivalent type as recommended

are to be used.

• Do not short-circuit the supply terminals.

• Remove batteries during long periods of non-use.

• Remove exhausted batteries from the toy.

• Dispose of batteries safely. Do not dispose of batteries in re.

RECHARGEABLE BATTERIES:

• Remove rechargeable batteries from the toy before charging.

• Rechargeable batteries are only to be charged under adult

supervision.

• Do not charge non-rechargeable batteries.

NOTE

This product is in Try-Me mode in the packaging. After opening the

package, turn Switch & Go Dinos® Dino Launcher 2-in-1 off and on

again to proceed with normal play. If the unit powers down or if the

light fades out during play, please install a new battery.

Disposal of batteries and product

The crossed-out wheelie bin symbols on products and

batteries, or on their respective packaging, indicates they

must not be disposed of in domestic waste as they contain

substances that can be damaging to the environment and

human health.

The chemical symbols Hg, Cd or Pb, where marked,

indicate that the battery contains more than the specied

value of mercury (Hg), cadmium (Cd) or lead (Pb) set out

in the Batteries and Accumulators Regulation.

The solid bar indicates that the product was placed on the

market after 13th August, 2005.

Please dispose of your product and batteries responsibly.

In the UK, give this toy a second life by disposing of it

at a small electricals collection point* so all of its materials can be

recycled.

Learn more at:

www.vtech.co.uk/recycle

www.vtech.com.au/sustainability

* Visit www.recyclenow.com to see a list of collection points near you.

PRODUCT FEATURES

1. Off/Low/High Volume Switch

To turn the unit On or to adjust the

volume, slide the Off/Low/High

Volume Switch to the Low or

High Volume position. To turn the

unit Off, slide the switch to the Off

position.

2. Talk Button

Press the Talk Button to hear fun

phrases and cool dinosaur sounds

with light effects in Dino mode, or to

hear fun phrases and great vehicle

sounds in Vehicle mode.

3. Auto-Switch Button

In Vehicle mode, press the Auto-

Switch Button to automatically switch

from Vehicle mode to Dino mode.

4. Launch Button

In Mega Car mode, press the Launch

Button to launch the race car and

switch into a Spinosaurus.

5. LED Lights

The LED Lights flash along with the

sounds in all modes.

6 Fireball Button

Press the Fireball Button to launch a

reball projectile.

7. Automatic Shut-Off

To preserve battery life, the unit will automatically shut off after

approximately 20 seconds without input. The unit can be turned

on again by pressing the Talk Button, or by switching between

Dino and Vehicle modes. The unit will also automatically turn off

when battery power is very low.

NOTE

If the unit powers down or if the light fades out during play, please

install a new battery.

1. Begin in Spinosaurus mode.

3. Push the back wheels up.

5. The Spinosaurus is now in

Vehicle mode.

2. Flip the tail towards the head

of the dino.

4. Flip the Dino’s mouth up and

then flip the legs towards the

head of the dino.

HOW TO SWITCH

Switching from Spinosaurus mode to Vehicle mode

Switching from Vehicle mode to Spinosaurus mode

Switching from Pterodactyl mode to Launcher mode

Press the Auto-Switch Button to automatically switch from Vehicle to

Spinosaurus mode.

1. Begin in Pterodactyl mode.

3. Flip the wing tips up and then

fold the wings towards the

Pterodactyl’s body.

2. Flip the head down towards

the Pterodactyl’s body.

4. Flip the feet up.

5. The Pterodactyl is now in

Launcher mode.

Combination

Insert the vehicle into the launcher to form the Mega Car.

Press the Launch Button to release the vehicle and auto-switch into

a Spinosaurus.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.

2. Keep the unit out of direct sunlight and away from any direct

heat source.

3. Remove the batteries when the unit is not in use for an extended

period of time.

4. Do not drop the unit on hard surfaces and do not expose the unit

to moisture or water.

TROUBLESHOOTING

If for some reason the program/activity stops working or malfunctions,

please follow these steps:

1. Please turn the unit OFF.

2. Interrupt the power supply by removing the batteries.

3. Let the unit stand for a few minutes, then replace the batteries.

4. Turn the unit ON. The unit should now be ready to play with again.

5. If the product still does not work, install a brand new set of batteries.

If the problem persists, please contact our Consumer Services

Department and a service representative will be happy to help you.

CONSUMER SERVICES

Creating and developing VTech® products is accompanied by a

responsibility that we at VTech® take very seriously. We make

every effort to ensure the accuracy of the information, which forms

the value of our products. However, errors sometimes can occur.

It is important for you to know that we stand behind our products

and encourage you to call our Consumer Services Department with

any problems and/or suggestions that you might have. A service

representative will be happy to help you.

UK Customers:

Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK)

Website: www.vtech.co.uk/support

Australian Customers:

Phone: 1800 862 155

Website: support.vtech.com.au

NZ Customers:

Phone: 0800 400 785

Website: support.vtech.com.au

PRODUCT WARRANTY/

CONSUMER GUARANTEES

UK Customers:

Read our complete warranty policy online at vtech.co.uk/warranty.

Australian Customers:

VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –

CONSUMER GUARANTEES

Under the Australian Consumer Law, a number of consumer

guarantees apply to goods and services supplied by VTech

Electronics (Australia) Pty Limited. Please refer to vtech.com.au/

consumerguarantees for further information.

IM-549303-001

Version:0

Visit our website for more

information about our products,

downloads, resources and more.

www.vtech.co.uk

www.vtech.com.au

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of VTech Switch and Go Dinos - Dino Launcher 2-in-1 in the language / languages: English as an attachment in your email.

The manual is 2.93 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

VTech Switch and Go Dinos - Dino Launcher 2-in-1 Manual

Product: