540496

Vortex VIPER HS-T Riflescope Manual

8
Zoom out
Zoom in
Previous page
1/11
Next page
15 14
HS-T
RIFLESCOPE
Align the elevation turret cap.
Align the windage turret cap.
3. After filling the center gap on the post with shims, replace the
elevation cap.
4. Align the turret cap so the “0” mark on the cap matches up with the
“0” reference line on the turret post. Again,
be sure not to rotate the actual turret
mechanism in the process.
5. Re-tighten the retaining screws, but
do not overtighten. Use of thumb and
forefinger on the short end of the hex
wrench will provide sufficient force.
1. Loosen the three retaining screws on windage turret cap.
2. Carefully rotate the cap until the “0” mark on the cap matches up
with the “0” reference line on the turret post. Be sure that the cap is
freely turning and that you don’t rotate the actual turret mechanism.
3. Re-tighten the windage knob retaining screws, but do not
overtighten. Use of thumb and forefinger on the short end of the hex
wrench will provide sufficient force.
Once the windage and elevation knobs
are correctly indexed to the zero mark,
temporary corrections can be safely dialed
into the scope without worry of losing the
original zero.
Indexing the Windage Knob
After obtaining a satisfactory zero, the CRS stop can be set if desired:
1. Loosen the three turret cap retaining screws on the elevation turret.
Gently pull the turret cap straight up and off of the turret post, being
careful not to rotate the turret post.
2. Slide the CRS shims on the center section of the turret post below
the V-grooved part.
Setting the CRS Stop and Indexing Elevation Knob
Alternate shim installation direction
with each shim.
Place CRS shims
in this groove.
Use as many shims as necessary to
completely fill up the space. Do not try
to force in a last shim once the clearance
is very close—a tiny remaining gap is
normal.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex VIPER HS-T Riflescope at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex VIPER HS-T Riflescope in the language / languages: English as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info