540500

Vortex DIAMONDBACK HP Riflescope Manual

5
Zoom out
Zoom in
Previous page
1/9
Next page
9 8
RIFLESCOPE
diamondback
Riflescope mounting
To get the best performance from your Diamondback HP riflescope,
proper mounting is essential. Although not difficult, the correct steps must
be followed. If you are unsure of your abilities, it would be best to use the
services of a qualified gunsmith.
Rings and Bases
Mount an appropriate base and matching rings to your rifle according
to the manufacturer’s instructions. Diamondback HP riflescopes require
1-inch rings.
Use the lowest ring height that will provide complete clearance of scope
and rifle—avoiding any contact with barrel, receiver, bolt handle or any
other part of the rifle. A low mounting height will help assure proper
cheek weld, aid in establishing a solid shooting position, and promote fast
target acquisition.
After installing the bottom ring halves on the mounting base, place the
riflescope on the bottom ring halves and loosely install the upper ring
halves. Before tightening the scope ring screws, adjust for maximum eye
relief to avoid injury from recoil:
Eye Relief and Reticle Alignment
1. Set the riflescope to the middle of its magnification range.
2. Slide the riflescope as far forward as possible in the rings.
3. While viewing through the riflescope in a normal shooting
position, slowly slide the riflescope back towards your face. Pay
attention to the field of view. Stop sliding the riflescope back as soon
as you see the full field of view.
4. Without disturbing the front-back placement, rotate the riflescope
until the vertical crosshair exactly matches the vertical axis of the
rifle. Use of a reticle leveling tool, a weight hung on a rope, flat feeler
gauges, or a bubble level will help with this procedure.
After aligning the reticle, tighten and torque the ring screws down per
the manufacturer’s instructions.
Using bubble levels to
square the riflescope to
the base.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex DIAMONDBACK HP Riflescope at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex DIAMONDBACK HP Riflescope in the language / languages: English as an attachment in your email.

The manual is 4,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info