778293

Vonroc PH509AC VULCANO Manual

5
Zoom out
Zoom in
Previous page
1/64
Next page
EN
5
WWW.VONROC.COM
TECHNICAL SPECIFICATIONS
Model No. PH509AC
Voltage 220-240 V~
Frequency 50-60 Hz
Power 2000 W
Power settings 1: 1000W
2: 2000W
Heating element type Carbon fibre lamp
Heating time 3 seconds
Wave length 3.0-1000 microns
Radiant efficiency
90%
Heating distance
2-3m
Heating area
7-9m
Colour temperature 1600 K
Overheat protection Yes
Electronic soft start Yes
Ingress protection class IP44
Protection class Class I
Weight 2.36 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Hanging chain
2. Power cable
3. Hanging hook
4. Carbine hook
5. On/off switch
6. Heater
7. Protective grill
8. Remote control
9. Remote control on/off button
10. Receiver for remote control with display
11. Down button
12. Up button
13. Timer button
14. Heat level button
3. ASSEMBLY
This heater should be installed by a
competent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Installing the heater (Fig. A, C)
Always mount the device with the supplied
accessories.
Before starting the installation, take the following
into consideration:
• Place the device on a firm, level ceiling surface;
installation of the heater should be on a strong
rigid support (such as strong wooden beams or
metal rails etc).
• The device must be hung so that there is 50
cm of free space between the heater and any
ceiling, tent canvas etc. There must also be
at least 1.80 m between the ground and the
underside of the device. Refer to Fig. C. The
device can never be hung on a hook in the wall
as it could hang at a slant!
• The Hook used to hang the heater must be able
to take a weight 3 or 4 times that of the heater
itself.
• Ensure that the power supply cable is well
mounted and that it does not come into contact
with reflector of the heater or that does not trail
into heated area.
• Do not install the heater on an inflammable
surface.
• If the heater is to be used outside, a weatherp-
roof outlet is highly recommended.
• Before drilling ensure that there are no wires or
water pipes in the area where the heater is to
be installed.
To install the heater, follow these steps:
• The device is supplied with a hanging chain (1)
and two carbine hooks (4). Put a carbine hook
(4) on both ends of the chain (1).
• Mount one side of the chain onto the hanging
hook (3) using the carbine hook (4), as shown
on fig. A.
• Provide an attachment point from which the
device can hang down freely and that is sturdy
enough to hold the heater without any problems.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vonroc PH509AC VULCANO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vonroc PH509AC VULCANO in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 4.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info