MAINTENANCE AND SERVICING
}}
485
Removing the rectangular headlight
cover
Most of the bulbs in the headlight housing can
be accessed when the rectangular cover has
been removed.
Before the rectangular cover can be removed, the
plastic covering must be removed, see the article
"Replacing bulbs" for information.
1. Loosen the cover's four screws with a T20
Torx screwdriver (1) but do not remove them
completely (turning them 3–4 turns is
enough).
2. Push the cover to the side.
3. Remove the cover.
Put the cover back in place in the reverse order.
Related information
•
Replacing bulbs (p. 483)
Replacing low beam headlight bulbs
On models with halogen headlights, the low
beam headlight bulb can be replaced by the
owner.
Before the bulb can be replaced, the plastic cov-
ering over the headlight housing has to be
removed, see the article "Replacing bulbs."
1. Remove the round rubber cover from the
headlight housing.
2. Remove the bulb by turning the bulb holder
upward and then pulling it straight out.
3. Carefully pry the plastic sleeve by the con-
nector's locking lug to release it.
4. Remove the connector from the bulb.
5. Insert a new bulb.