MAINTENANCE AND SERVICE
667
Touching up minor paintwork
damage
Paint is an important part of the car's rust-
proofing and should therefore be checked
regularly. The most common types of paint-
work damage are stone chips, scratches, and
marks on e.g. the edges of wings, doors and
bumpers.
To avoid the onset of rust, damaged paintwork
should be rectified immediately.
NOTE
When paint is repaired the surface must be
clean and dry. The temperature of the sur-
face should be at least 15 °C (59 °F).
Materials that may be needed
•
Primer – a special adhesive primer in a
spray can is available for e.g. plastic-
coated bumpers.
•
Basecoat and clearcoat - available in spray
cans or as touch-up pens/sticks
16
.
•
Masking tape.
•
Fine sand paper.
Applying touch-up paint to the
damaged surface
If the damage has not reached down to the
metal, the touch-up paint can be applied
directly after the surface has been cleaned.
1. Apply a piece of masking tape over the
damaged surface. Then remove the tape
to remove any loose paint.
If the damage is down to the metal, use of
a primer is appropriate. In the event of
damage to a plastic surface, an adhesive
primer should be used to give better
results - spray into the lid of the spray can
and brush on thinly.
2. Before painting, gentle polishing using a
very fine polishing agent may be carried
out locally if required (e.g. if there are any
uneven edges). The surface is cleaned
thoroughly and left to dry.
3. Stir the primer well and apply using a fine
brush, a matchstick or similar. Finish off
with a basecoat and clearcoat once the
primer has dried.
For scratches, implement the same procedure
but mask around the damaged area to protect
the undamaged paintwork.
Touch-up pens and spray paints for touching
up paintwork are available from Volvo dealers.
NOTE
If the stone chip has not penetrated down
to the meal and an undamaged layer of
paint remains in place, fill in with base coat
and clear coat as soon as the surface has
been cleaned.
Related information
•
Car paintwork (p. 666)
•
Colour codes (p. 668)
16
Follow the instructions that are included with the package for the touch-up pen/stick.
