09 Maintenance and specifications
Replacing bulbs
09
327
Headlight housing
The entire headlight housing must be lifted
out when replacing all front bulbs.
Removing the headlight housing
Pull out the headlight housing's locking
pins.
Pull the headlight housing straight out.
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
Unplug the wiring connector by holding
down the clip with your thumb.
Pull the connector out with the other
hand.
5. Lift out the headlight housing and place it
on a soft surface to avoid scratching the
lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into
place.
2. Reinstall the headlight housing and lock-
ing pins. Check that they are correctly
inserted.
The headlight housing must be properly
in place and the wiring connector cor-
rectly reconnected before the lighting is
switched on or the remote key is inserted
into the ignition slot.
3. Check that the lights function properly.
Removing the cover to access the
bulbs
NOTE
Before starting to replace a bulb, see
page 326.
1. Open the retaining clamp by pressing it
upward/outward.
2. Press down the clips on the cover and
remove it.
Reinstall the cover in the reverse order.
