Manual Voltcraft VC271 SE (page 48 of 136) (English, German, Dutch, French)

738288

Zoom out

Zoom in

1/136

f) DC voltage mode (“mV ”)

Follow the steps below to measure mV/DC voltages:

- Switch on the DMM and select the “mV

” measurement mode.

“DC” and “mV” will appear on the display.

- Plug the red lead into the V terminal (G) and the black lead into the

COM terminal (H).

- Connect the two measuring probes in parallel to the object that

you want to measure (e.g. generator or circuit).

- The measurement will appear on the display.

- After taking a measurement, remove the leads from the measured

object and switch off the DMM.

 The“V/AC”rangehasaninputresistanceof≥10MΩ.This

means that there is almost no load on the circuit.

g) LoZ voltage mode

LoZmodeallowsyoutomeasureDCandACvoltageswithalowimpedance(approx.400kΩ).Inthismode,the

multimeter lowers the internal resistance to prevent ‘phantom’ voltage readings. As a result, the circuit is more heavily

loaded than in the standard measuring mode.

ToenableLoZmode,pressthe“Lowimp.400kΩ”button(J)whentakingavoltagemeasurement.Theimpedancewill

be reduced until you release the button.

“LoZ” (B17) will appear on the display.

LoZ mode can only be used for circuits with a voltage of up to 250 V for a maximum of 3 seconds. This

function is not available in mV mode.

After using LoZ mode, leave the multimeter for 1 minute before using it again.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC271 SE in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Voltcraft VC271 SE Manual

Product: