738288

Voltcraft VC271 SE Manual

38
Zoom out
Zoom in
Previous page
1/136
Next page
38
3. Intended use
- Measures and displays electrical parameters in measurement category CAT III (up to 600 V). Complies with the
EN 61010-1 standard and all lower categories.
- Measures direct and alternating voltages up to 600 V
- Measures direct and alternating currents up to 10 A
- Measures frequency from 10 Hz to 10 MHz (max. 20 Vrms)
- Measures capacitance up to 40 mF
- Measuresresistancesupto40MΩ
- Continuitytests(<10Ωacoustic)
- Diode tests
The measuring mode can be selected using the control dial. The measurement range is selected automatically in most
modes (except continuity test, diode test and current measuring mode).
Effective (True RMS) measurements are displayed when measuring AC voltages/currents with a frequency of up to
400 Hz. This ensures that sinusoidal and non-sinusoidal voltage/currents are measured accurately.
Negative polarity readings are indicated with the (-) sign.
The multimeter features a low-impedance function (LoZ) that enables you to measure the voltage with reduced in-
ternal resistance. This suppresses phantom voltages that may appear in high-impedance measurements. The low-
impedance function must only be used to measure circuits of up to 250 V for a maximum of 3 seconds.
The two current measurement inputs are protected against overload. The voltage in the measuring circuit must not
exceed 600 V.
The 10 A current measuring input is equipped with a ceramic high-performance fuse.
The mA/µA measuring input is equipped with resettable PTC fuses. In the event of an overload, the fuses restrict the
owofcurrenttoprotectthemultimeter.Youdonotneedtoreplacethefuses.
Themultimeterispoweredbyastandard9Vblockbattery(type6F22,NEDA1604oridenticalspecications).Only
usebatteriesofthespeciedtype.Rechargeablebatterieshavealowercapacityandshouldnotbeused.
The device switches off automatically after 15 minutes if no buttons are pressed. This prevents the battery from drain-
ing. The automatic power-off function can be disabled.
A fold-out stand is attached to the back of the multimeter. This allows you to place the multimeter on a level surface
for better readability.
Do not use the multimeter when the battery compartment is open or when the battery compartment cover is missing.
Do not take measurements in potentially explosive areas, damp rooms or adverse conditions. Adverse conditions
include:Moistureorhighhumidity,dustandammablegases,vapoursorsolvents,thunderstorms,andstrongelec-
tromagneticelds.
Forsafetyreasons,onlyusetestleadsoraccessoriesthatmatchthemultimeter’sspecications.
The multimeter must only be used by people who are familiar with the relevant regulations and understand the poten-
tial hazards. The use of personal protective equipment is recommended.
Using this product for any purposes other than those described above may damage the product and result in a short
circuit,reorelectricshock.Theproductmustnotbemodiedorreassembled!
Read the operating instructions carefully and keep them in a safe place for future reference.
Always observe the safety information in these instructions.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft VC271 SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC271 SE in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info