738218

Voltcraft VC165 Manual

36
Zoom out
Zoom in
Previous page
1/96
Next page
36
Proceed as follows to measure a current > 200 mA:
- Switch on the DMM at the dial switch (4) and select the measuring
range “A”.
- DC shows the measuring function for direct current in the display. If
you want to measure alternating current, push the button “SELECT”
once briey. The display switches to “AC” and you will see “TRMS”
for actual effective value measurement. Pushing again switches back
to “DC”, etc.
- Plug the red measuring line into the V measuring jack (5) and the
black measuring line into the COM measuring jack (6).
- Connect the two measuring prods in series with the consumer. The
red measuring prod indicates the positive pole, the black measuring
prod the negative pole. Switch on the measuring circuit.
- The measured value is indicated on the display.
When a minus “-” appears in front of the measured value when measuring direct current, the current has
the opposite direction (or the measuring lines have been swapped).
- Power down the measuring circuit after the end of measuring and remove the measuring prods from the measured
object. Switch off the device. Turn the dial switch to “OFF”.
Proceed as follows to measure a current < 200 mA:
- Switch on the DMM by the dial switch (4) and select the corresponding measuring range “mA/µA”.
- DC shows the measuring function for direct current in the display. If you want to measure alternating current, push
the button “SELECT” once briey. The display switches to “AC” and you will see “TRMS” for actual effective value
measurement. Pushing again switches back to “DC”, etc.
- Plug the red measuring line into the mA measuring jack (7) and the black measuring line into the COM measuring
jack (6).
- Connect the two measuring prods in series with the consumer. The red measuring prod indicates the positive pole,
the black measuring prod the negative pole. Switch on the measuring circuit.
- The measured value is indicated on the display.
When a minus “-” appears in front of the measured value when measuring direct current, the current has
the opposite direction (or the measuring lines have been swapped).
- Power down the measuring circuit after the end of measuring and remove the measuring prods from the measured
object. Switch off the device. Turn the dial switch to “OFF”.
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft VC165 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC165 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info