536171
34
Zoom out
Zoom in
Previous page
1/62
Next page
For the continuity check, press button "S" (5) until the symbol
appears in the display. If you continue to press it, you will switch to
the next measuring area (dode test, resistance, continuity ...).
As soon as "OL" appears in the display, you have exceeded the mea-
suring area or the measuring circuit has been broken.
Diode test
For this measurement, proceed as follows:
- Switch area selection switch (10) to position .
- Press button "S"(5) twice to switch over to the diode test area.
The diode symbol appears in the display.
- Now connect the two measuring prods with the object to be mea-
sured (diode). The conducting-state voltage is displayed.
If you test a diode in the conducting direction(rred measu-
ring prod on the anode = diode side without ring marking),
you will measure a voltage from approx. 0.6 V (silicon
diode), as long as the diode route is not defective.
If you measure on the other hand in the blocked direction
(red measuring line on the cathode = diode side with ring
marking), "OL" will appear in the display.
If, on the other hand, a "voltage figure" is displayed, you
have either connected the object to be measured incor-
rectly or it is defective.
34
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft VC-86 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC-86 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info