681145

Voltcraft SL-200 Manual

23
Zoom out
Zoom in
Previous page
1/44
Next page
Calibration
This sound level detector complies with the European Standard EN 61672-1:2014-07 (IEC
61672:2013) for sound level meters. To be able to use it in compliance to the standards, the
meter must be calibrated before every measurement using evaluation curve A (dBA) i.e. it must
be checked using an optional sound calibrator and adjusted as required.
Accuracy must once more be checked after each measurement.
To calibrate, proceed as follows:
• Switch the sound level detector on.
• Select the appropriate settings (dBA, Hi or Lo measurement range and FAST time evaluation)
• If required, deactivate the „MAX“ and „HOLD“ functions.
• Plug the microphone of the sound level detector into the opening of the sound calibrator.
Make sure that it sits tightly to ensure that the calibration chamber in the sound calibrator
is sealed.
• Set the following parameters at the sound calibrator: 94 dB at 1 kHz
• The meter should now display a sound level of 94 dBA. If this is not the case then the meter
must be adjusted.
• Open the battery compartment at the rear of the device and remove the battery. Do not
disconnect the battery!
• You can now see two alignment points in the battery compartment.
• Using a suitable screwdriver, carefully turn the adjustor for your measurement range until the
display is set to exactly 94.0 dBA.
A(Lo) = Calibration controller for the Lo measurement range
A(Hi) = Calibration controller for the Hi measurement range
• Carefully re-close the battery compartment.
Making measurements
Sound sources must always be measured directly.
Make sure that there are no objects or persons located between the microphone and
the sound source.
Point the sound level detector and the microphone directly at the sound source.
To ensure that you do not inuence the sound waves yourself, stretch the meter out with your
arm as far away from your body as possible or mount the meter onto a stand. There is a xture
for a stand on the rear of the housing.
Avoid vibration and movement.
23
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft SL-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft SL-200 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info