536351

Voltcraft P-600 LCD Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
OPERATING INSTRUCTIONS
VERSION 06/12
UNIVERSAL CHARGER P-600 LCD
ITEM NO.: 20 26 00
INTENDED USE
The charger is intended to charge or discharge one to four NiMH rechargeable batteries of types AAA / AA /
C / D. It can also charge one or two rechargeable 9 V-block batteries. One USB device can also be charged
separately.
The charger integrates the minus delta voltage (-ΔV) function, which monitors the voltage over the charging
cycle. When the battery pack is fully charged, the charger will begin a trickle charging automatically, to keep
the battery at its optimum capacity level. The charger has short-circuit, overload, wrong polarity and wrong
polarity detection function.
The charger is powered by 100 – 240 V/AC, 50 or 60 Hz mains outlet. Only operate the charger in a dry,
indoor environment. Do not expose it to moisture.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, re, electric shock etc. Read the instructions carefully and
keep them. Make this product available to third parties only together with its operating instructions.
DELIVERY CONTENT
Battery charger•
Power adapter•
Operating instructions•
SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
Persons / Producta)
Sufcient ventilation is essential when operating the charging unit. Never block the ventilating •
slots on the sides of the housing.
Never place the unit on a table cloth or on a carpet. Place the unit on a level, solid and ame-•
resistant surface.
The product should not be connected immediately after it has been brought from an area of •
cold temperature to an area of warm temperature. Condensed water might destroy the product.
Wait until the product adapts to the new ambient temperature before use.
The device is not a toy. Keep it out of the reach of children and pets.•
Do not leave packaging material lying around carelessly. These may become dangerous •
playing material for children.
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, •
moisture, ammable gases, vapours and solvents.
Do not place the product under any mechanical stress.•
If it is no longer possible to operate the product safely, take it out of operation and protect it from •
any accidental use. Safe operation can no longer be guaranteed if the product:
is visibly damaged, -
is no longer working properly, -
has been stored for extended periods in poor ambient conditions or -
has been subjected to any serious transport-related stresses. -
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage •
the product.
Also observe the safety and operating instructions of any other devices which are connected •
to the product.
Rechargeable batteriesb)
This charger is intended for rechargeable Ni-MH batteries only. Attempting to charge other •
types of batteries may cause personal injury or damage to the charger.
The manufacturer’s instructions for the respective batteries must be observed, before they •
are charged.
Correct polarity must be observed while inserting the rechargeable batteries.•
Rechargeable Batteries should be removed from the device if it is not used for a long period •
of time to avoid damage through leaking. Leaking or damaged rechargeable batteries might
cause acid burns when in contact with skin, therefore use suitable protective gloves to handle
corrupted rechargeable batteries.
Rechargeable batteries must be kept out of reach of children. Do not leave the battery lying •
around, as there is risk, that children or pets swallow it.
All the batteries should be replaced at the same time. Mixing old and new batteries in the •
device can lead to battery leakage and device damage.
Batteries must not be dismantled, short-circuited or thrown into re. Never recharge non-•
rechargeable batteries. There is a risk of explosion!
Miscellaneousc)
Consult an expert when in doubt about operation, safety or connection of the device.•
Maintenance, modications and repairs are to be performed exclusively by an expert or at a •
qualied shop.
If you are not sure about the correct connection or use, or if questions arise which are not covered by
these operating instructions, please do not hesitate to contact our technical support or another qualied
specialist.
Voltcraft®, Lindenweg 15, D-92242 Hirschau, Tel. +49 180/586 582 7.
OPERATING ELEMENTS
9 V battery connector1.
Release button for cover2.
“D” button for discharge function3.
LCD screen4.
“L” button for backlight function5.
Negative terminal for AAA / AA / C / D battery compartment6.
Power socket7.
USB socket 8.
POWER SUPPLY
Connect the provided power cord to the power socket (7) of the charger.1.
Plug the power adapter to the mains outlet.2.
The LCD screen (4) displays blue backlight for 3 seconds, indicating power has been connected. If there 3.
are no batteries in the unit, the screen displays the USB Function Indicator.
LCD DISPLAY
To turn on the blue backlight on the LCD, press the button “L” (5). The light will turn on for 10 seconds.
The charging status and the battery capacity is shown on the screen during charging / discharging.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft P-600 LCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft P-600 LCD in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info