Misapplication (too high charging current, wrong poles, shorting charging terminals) of •
the charging unit could overcharge or destroyed the battery. In worst case scenario, the
battery might explode and cause considerable damage.
The charging unit should not be switched on immediately after bringing it in from a cold •
to warm room. Condensed water might impair or destroy your unit. Give the charger time
to warm up to room temperature without switching it on.
Neither this device nor battery is not a toy and should be kept out of reach of children! •
Servicing, adjustment or repair works must only be carried out by a specialist/ specialist •
workshop.
If any questions arise that are not answered in this operating manual, contact our •
Technical Advisory Service or other experts.
3. OPERATING ELEMENTS
1. Power receptacle
2. Battery compartments
3. Number buttons
Press respective number button to select a particular battery compartment for charging
and to display the operating mode
4. “DISPLAY” button
Press “DISPLAY” button to select the displays of the charging current (in mA), time
elapsed (in hh:mm), the terminal voltage (in V) and accumulated capacities (in mAh or
Ah) during the charging or discharging process.
5. “CURRENT” button
Press “CURRENT” button to select the amount of current to be applied (within the rst
8 seconds after batteries are inserted) in different operating modes.
6. “MODE” button
The “MODE” button shall rst be pressed and held for about 1 second to activate
the mode change.
The subsequent pressing of the mode key will enable to toggle among the “Charge”,
“Discharge”, “Test” and “Refresh” mode.
7. Different display modes are shown:
displays, charging current (mA), battery voltage (V), accumulated capacities (mAh) or
time elapsed (hh:mm).
8. Different operating modes are displayed.
16
