633398

Voltcraft 122953 - Colour Analysis Manual

19
Zoom out
Zoom in
Previous page
1/50
Next page
18
Display symbols
R Colour value for red
G Colour value for green
B Colour value for blue
Hue Measuring value for the colour hue
Sat Measuring value for the colour saturation
Lum Measuring value for the luminance
Battery replacement symbol; please replace the batteries immediately to avoid measuring errors!
Mesu Measuring in progress. The sensor may not be moved or lifted.
CAL RGB calibration in progress. The sensor may not be moved or lifted.
RS232 Interface is active, data transfer in progress.
Button functions
POWER Power switch; to switch the unit on and off
TEST A push of this button starts measuring. You do not have to keep this button depressed.
Function Function button, which enables white calibration in connection with the „CAL“ button
CAL Calibration button, which enables white calibration in connection with the „Function“ button
REL Button for simple comparison measurement (shows the difference between original and sample)
RGB/HSL Button for switching between RGB and HSL measuring mode
LIGHT Button for turning the integrated sensor illumination on/off
Initial operation
Inserting the batteries
Before the initial operation of this meter, you must first install a new 9V block (alkaline) battery. A power pack
unit can be used optionally. Battery installation and power pack operation are described in the „Maintenance
and cleaning“ section.
Connecting the measuring sensor
Connect the round plug of the sensor (17) with the socket „PROBE INPUT“ (6) on the measuring device. The
plug is protected against wrong polarity and only fits into the socket in the right direction. Observe the arrow
marking on the plug. This marking points towards the back of the device. Make sure that the plug is firmly
inserted otherwise inaccurate measurements will be made.
Setting up the measuring device
For better reading, the measuring device can be set up using the bracket on the rear (13).
The device can be mounted on a tripod using the tripod socket (10)
Automatic cutoff function
To save on the unnecessary usage of battery power, an automatic switch-off function has been built-in. The
device is automatically switched off if no button has been pressed over a period of about 3 minutes. You can
switch the device back on with the „Power“ button (3).
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft 122953 - Colour Analysis at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft 122953 - Colour Analysis in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info