519761
5
Zoom out
Zoom in
Previous page
1/157
Next page
VIVOTEK
User's Manual - 5
Hardware Reset
The reset button is used to reset the system or restore the factory default settings Sometimes
resetting the system can return the camera to normal operation If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks Note that
all settings will be restored to factory default Upon successful restore, the status LED will blink
green and red during normal operation�
Installation
Hardware Installation
First, use the supplied screwdriver to detach the dome cover from the camera base� Insert your MicroSD/
SDHC Card if necessary
Then, follow the steps below to install the camera to either the ceiling or the wall:
1� Attach the supplied alignment sticker to the ceiling/wall�
2� Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall� Then hammer
the plastic anchors into the holes if necessary
3� This Network Camera can be mounted with the cable routed through the ceiling/wall or from
the side� If you want to feed the cable through the ceiling/wall, drill a cable hole A as shown in
the picture� If the cable goes through the side of the dome cover, please remove the rubber
stopper (B)�
Network Camera
Model No: MD7530
Made in Taiwan
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pat. 6,930,709
RoHS
V I
MAC:0002D107258A
Record the MAC address
before installing the camera�
Reset Button
Status LED
Dome Cover
Tamper-proof Screw
Camera Base
Rubber Stopper
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vivotek MD7530 Smart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vivotek MD7530 Smart in the language / languages: English as an attachment in your email.

The manual is 7,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vivotek MD7530 Smart

Vivotek MD7530 Smart Quick start guide - English - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info