Manual Vivanco FMH 7190 (page 4 of 26) (English, German, Dutch, French, Italian, Spanish)

63555

Zoom out

Zoom in

1/26

FMH 7190

Congratulations on purchasing your new Vivanco product. This wireless headphone

system operates using the latest transmission technology. Enjoy your favourite music or

films in top quality stereo sound without inconvenient cable connections. With the SRS

TruSurround XT® System you can also convert any normal stereo sound into breathtaking

virtual surround sound.

A Transmitter

1 Charging indicator light

2 Operation indicator light

3 SRS TruSurround XT®* indicator light

4 SRS TruSurround XT®* switch

5 Channel selection switch

6 Audio connecting cable

7 AC adaptor connector

8 AC adaptor

9 RCA adaptor

10 Jack adaptor 3.5 mm to 6.35 mm

B RF headphone

1 Charging contacts

2 Earshell with battery compartment

3 On/off switch (OFF/ON)

4 Volume control (VOL)

5 Operation indicator light

6 Channel selection button (TUNE)

7 Balance control left/right (L/R)

Important information

Please read these operating instructions carefully and keep them in a safe place.

ᮣ

Do not use the devices in water or rain.

ᮣ

The AC adaptors are designed for these devices only. Do not use the supplied AC

adaptors with other devices.

ᮣ

Avoid exposure to extreme heat or strong light.

ᮣ

Do not open the housings or the AC adaptors (danger of electric shock!).

ᮣ

Check whether the local mains voltage corresponds to the voltage indicated on the

AC adaptor.

ᮣ

Avoid touching the battery or charging contacts. Do not touch the contacts with

metal objects.

ᮣ

Do not cover the devices (e.g. with a towel, sheet, etc.)

ᮣ

Clean the devices using a moist cloth and never use aggressive cleaning agents.

ᮣ

Constant use at high volumes impairs your hearing and may cause permanent

damage.

ᮣ

Do not dispose of this product with the domestic waste; take it to your local

electronic waste recycling depot.

Preparing your RF headphone

1. Place the transmitter near to your hi-fi system, your TV or another audio source.

2. Connect the AC adaptor to the connector on the transmitter, then plug it into a mains

socket.

3. Connect the audio connecting cable to a headphone output, or to a line out or rec.

out output. Set the volume of your audio source to 1/4 to 1/3 of the maximum

volume.

If the charge indicator doesn’t change to red, move the handset back and forth slightly

in the charging shell until the charging contacts snap into place correctly and the

charge indicator changes to red.

5. Insert the supplied batteries as described in the chapter "Using batteries or

rechargeable batteries".

6. Switch on the RF headphone via the on/off switch.

7. Press the channel selection button on the RF headphone in order to automatically

locate the transmitter. If the transmitter has been located, the operating indicator

lights up green.

8. Your device is now ready for operation.

Explanation of functions

SRS TruSurround XT®*

The SRS TruSurround XT ®* technology allows you to play a surround sound audio source

(for example DVD) on a stereo headset in comparable quality. You can turn this virtual

surround sound on or off depending on your need, by simply pressing the SRS

TruSurround XT®* switch. If the effect is switched on, the display is blue. You achieve

the ideal surround effect if your audio source plays the audio data in Dolby Pro Logic or

Pro Logic II quality.

Auto-Tuning

If interference is received, select a different channel on the transmitter (channel select

switch). Then press the channel select button on the RF headphone and the new

transmitter is located automatically.

Balance

You can adjust the loudness ratio between the left and right channels. Turn the balance

control in the respective direction. The middle position produces a balanced sound image

between the left and right sides of the music signal.

Standby mode

The transmitter switches automatically to standby mode if it does not receive any signal

for 2 minutes or if the signal is too quiet. It switches automatically back to transmission

mode as soon as a signal is present again.

Using batteries or rechargeable batteries

Opening the battery compartment

1. To open the battery compartment, carefully pull off the ear cushion from the left side

earshell "L". The battery compartment is located behind this.

2. Insert the batteries or rechargeable batteries (micro, type AAA) into the battery

compartment, observing the correct polarity.

3. Place the ear cushion over the battery compartment again and press it carefully until

it latches.

ᮣ

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Vivanco FMH 7190 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Vivanco FMH 7190 Manual

Product: