653443
7
Zoom out
Zoom in
Previous page
1/23
Next page
7
Cover with Removable Hinge Design
Cover Door:
1. The Cover Door can be removed by opening it until the door is horizontal. Then,
gently spread the sides of the door over the round hinges and remove.
2. To reinstall the Cover Door, gently spread the sides of the door and place the door
hinge cutouts over the round hinges. (Figure C)
Back Cover:
1. To remove the Back Cover from the Blending Station:
a. First remove the Cover Door from the unit, as described above.
b. Remove the two (2) Back Cover mounting screws located on the rear of the
machine. (Figure D)
c. From the rear of the machine, firmly push the bottom of the cover forward
(towards the control panel), keeping the bottom edge of the cover against the
motor base.
DO NOT tilt or strike the cover during removal.
d. Slide forward until the side latches on the front of the cover are released from the
motor base.
DO NOT strike the cover to “pop” the side latches from their
tracks. Doing so will cause damage. The cover must only be removed by
sliding it forward (toward the Control Panel).
2. To replace the Back Cover on to the Blending Station:
a. Place the Back Cover on the motor base approximately one (1) inch forward of its
normal position.
b. Slide the cover towards the back of the machine (away from the Control Panel).
Make sure the side latches slide into their tracks.
c. Push until back of cover is seated against the Motor Base.
Make sure the Back Cover is fully seated in the back and the side latches
are in their grooves before inserting and tightening the mounting screws.
d. Replace and firmly tighten the two (2) Back Cover mounting screws. (Figure D)
DO NOT overtighten. DO NOT use the mounting screws to pull the Back
Cover into position. Doing so will cause damage.
Figure C
Figure D
Back Cover
Hinge
Mounting
Screws
Back Cover
Cover Door
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vitamix T G 2 - Blending Station at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vitamix T G 2 - Blending Station in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info