Manual Visonic PowerMax Express (page 18 of 36) (English)

580333

Zoom out

Zoom in

1/36

18 D-302989

41: CANCEL ANNOUN

enable

disable

42: ABORT ANNOUNC

enable

disable

Applicable

in the

USA

Applicable

in the

USA

34: AC FAIL REP

5 minutes

30 minutes

60 minutes

180 minutes

33: CONFIRM TIME

disable

30 minutes

45 minutes

60 minutes

90 minutes

36: USER PERMIT

enable

disable

in UK

39: KEY ZONES OPT

z. 21-28 enable

disable option

z. 29 enable

z. 21-29 enable

DEL KEY’s ON /OFF

43: CP-01

enable

disable

returns to

“01: ENTRY DELAY 1”

Applicable

in the USA

Figure 4.4 - DEFINE PANEL Flow Chart

4.5 DEFINING COMMUNICATION PARAMETERS

Preliminary Guidance

This mode allows you to adapt the telephone

communication parameters to the local requirements.

Compatible central station receivers are:

Osborne-Hoffman model 2000, Ademco Model 685,

FBII Model CP220, Radionics Model D6500, Sur-Gard

Model SG-MLR2-DG and Silent Knight Model 9500.

IMPORTANT: In telephone / pager number locations and

account number locations, you may be required to enter

hexadecimal digits. In telephone number locations, these

digits are used as codes to control the dialer:

Hex.

Digit

Keying

Sequence

Code

Significance

A <#>

⇒

<0> Applicable only at the beginning of a

number - the dialer waits 10 seconds

or waits for dial tone, whichever

comes first and then dials.

D <#>

⇒

<3> Applicable only at the beginning of a

number - the dialer waits 5 seconds

for dial tone and goes on hook if none

is received.

E <#>

⇒

<4>

pplicable only in the middle of the

number - the dialer waits 5 seconds

F <#>

⇒

<5> Not applicable in phone numbers

Note: A "+" can be entered at the beginning of the line by

pressing

and then .

To enter a series of digits, use the following keys:

<Numeric keypad> - to enter the number

- moves the cursor from left to right

- moves the cursor from right to left

- deletes everything after the cursor (to the right)

4.5.1 PSTN / GSM (Fig. 4.5 Detail A)

Area Code [Fig 4.5.1(1)]

Here you enter the system tel. area code (up to 4 digits).

Line Prefix [Fig 4.5.1(2)]

Here you enter the number that is used as a prefix to

access an outside telephone line (if exists).

Dial Method [Fig 4.5.1(3)]

Here you determine the dialing method used by the automatic

dialer built into the PowerMaxExpress control panel.

The options are: Pulse and tone (dtmf).

GSM Keep Alive [Fig 4.5.1(4)]

Here you prevent the GSM service provider from

disconnecting the GSM line if the user has not initiated any

outgoing telephone calls during the last 28 days.

The options are: disable and every 28 days.

4.5.2 GPRS / BB [Fig. 4.5 Detail B]

The GSM/GPRS module is capable of communicating with

the Central Station receiver by GPRS, GSM Voice and

SMS channels. Each of the channels can be separately

enabled or disabled in order to allow or prohibit the module

from using it for the event reporting. If all channels are

enabled, the GSM/GPRS module will always try GPRS

first. If fails, it will try GSM Voice. If fails, it will try any other

possible method (PSTN, Broadband) and only then it will

try SMS. This is due to the fact that SMS is the most

unreliable option of communication. Disabling any of the

GSM Module channels will cause the module to use a

different sequence than the one described above.

GPRS Report [Fig 4.5.2(1)]

Here you determine whether the alarm system will report

events to the central station via the GPRS channel.

The options are: disable and enable.

GSM Report [Fig 4.5.2(2)]

Here you determine whether the alarm system will report

events to the central station via the GSM voice channel.

The options are: disable and enable.

SMS Report [Fig 4.5.2(3)]

Here you determine whether the alarm system will report

events to the central station via the SMS channel.

The options are: disable and enable.

GPRS APN [Fig 4.5.2(4)]

Here you enter the name of the APN (Access Point) used for

the internet settings for the GPRS (up to 40 digits).

GPRS Username [Fig 4.5.2(5)]

Here you enter the username of the APN used for GPRS

communications (up to 30 digits).

GPRS Password [Fig 4.5.2(6)]

Here you enter the password of the APN used for GPRS

communications (up to 16 digits).

The following table provides a list of the keys used by the

PowerMaxExpress editor for the GPRS APN, GPRS

Username, GPRS Password menus and Custom Zone

Name option.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Visonic PowerMax Express in the language / languages: English as an attachment in your email.

The manual is 3,94 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Visonic PowerMax Express

Visonic PowerMax Express User Manual - Dutch - 35 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Visonic PowerMax Express Manual

Product: