667314
58
Zoom out
Zoom in
Previous page
1/376
Next page
18
0478 111 9918 F - EN
Push the upper blade
(29a) to the left as far as
the stop and then lift the
opposite side.
The upper blade (29a) is
then disengaged from
the lower blade (29b) by
pushing to the right.
Loosen the
26= blade fastening screw(s)
using an A/F 17 spanner
and remove together
with the
27= retaining washer or
28= guard plate.
Remove
29= mowing blade together
with
40= thrust washer.
MB 650 VM, MB 655 VM:
The
29= mowing blade consists
of an upper blade (29a)
and a lower blade (29b).
It can be separated for
convenient regrinding.
Risk of injury!
Always wear
gloves.
The following points must be
observed when re-sharpening
the mowing blade:
Cool the mowing blade
when sharpening, e.g. with
water. The blade must not
be allowed to display blue
colouring, as this would
reduce its cutting quality.
Sharpen blades evenly to
prevent vibration due to
imbalance.
Sharpening the
mowing blade
28
Removing the mowing
blades
If mowing results deteriorate
with time, the mowing blade is
probably blunt.
CAUTION
Risk of injury!
A worn blade may break off
and cause serious injuries.
The instructions for blade
maintenance must therefore
always be observed.
Blades are subjected to
differing degrees of wear
depending on the location
and duration of use. If you
use the mower on sandy
ground or use it frequently
under dry conditions, the
blade will be subjected to
greater loads and will wear
more quickly than the
average.
Always replace the blade
fastening screw(s) (26),
retaining washer (27) and
guard plate (28) when
replacing the mowing blade.
Multi-blade (MB 650 VM,
MB 655 VM):
The blade thickness must be
at least 2 mm at any point.
(Check using slide calliper).
The blades may not be
ground back to a width of
under 40 mm during
sharpening.
When inspecting, place a
25= ruler against the rear
blade edge and check for
wear on the lower and
upper blades.
Wear limits:
Standard blade:
The blade thickness must be
at least 2.5 mm at any point.
(Check using slide calliper).
The blades may not be
ground back by more than
5 mm during sharpening.
When inspecting, place a
25= ruler against the front
blade edge and check for
wear.
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 655RS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 655RS in the language / languages: All languages as an attachment in your email.

The manual is 41,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info