667224
44
Zoom out
Zoom in
Previous page
1/269
Next page
0478 111 9922 B - EN
42
Fault:
Engine does not start
Possible cause:
Motorstop lever not pressed.
No fuel in tank; fuel line blocked.
Inferior, dirty or old fuel in tank.
Air filter dirty.
Spark plug socket detached from spark
plug; ignition lead not properly fastened
to socket.
Spark plug dirty or damaged; incorrect
electrode gap.
Primer not actuated (MB 248,
MB 248 T).
Remedy:
Press motorstop lever to handlebar and
hold. (Ö 10.1)
Top up fuel; clean fuel line. #
Always use fresh, good quality fuel,
unleaded petrol; clean carburettor. #
Clean air filter. #
Connect spark plug socket; check
connection between ignition lead and
socket. #
Clean or replace spark plug; adjust
electrode gap. #
Press primer three times before
starting. (Ö 10.1)
Fault:
Starting problems or deteriorating engine
power.
Possible cause:
Lawn mower housing blocked.
Mowing at an excessively low cutting
height or propulsion speed is too high in
relation to the cutting height.
Water in fuel tank and carburettor;
carburettor blocked.
Fuel tank contaminated.
Air filter dirty.
Spark plug dirty.
Remedy:
Clean lawn mower housing (detach
spark plug socket!). (Ö 11.2)
Select a higher cutting height or reduce
the pushing speed. (Ö 7.7)
Empty fuel tank, clean fuel line and
carburettor. #
Clean fuel tank. #
Clean air filter. #
Clean spark plug. #
Fault:
Engine overheating.
Possible cause:
Oil level in engine too low.
Cooling ribs dirty.
Remedy:
Change engine oil. (Ö 7.8)
Clean cooling ribs. (Ö 11.2)
Fault:
Excessive vibration during operation.
Possible cause:
Cutting unit defective.
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
WAd
98 dB(A)
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
pA
86 dB(A)
Uncertainty K
pA
1 dB(A)
Specified vibration
characteristic in
accordance with
EN 12096:
Measured value a
hw
6.40 m/sec
2
Uncertainty K
hw
Measurement in
accordance with
EN 20643
2.56 m/sec
2
L/W/H: 160/55/106 cm
Weight: 30/33 kg
MB 248.3 / MB 248.3 T
MB 253.0 / MB 253.0 T:
Safety device: Motorstop
Starter: Rope start
Tightening torque for
blade fastening
screw: 60 - 65 Nm
Self-propulsion, rear
wheels (MB 248.3 T/
MB 253.0 T) 1 forward gear
Wheel dimensions,
front: 180 mm
Wheel dimensions,
rear: 200 mm
Cutting height: 25 - 75 mm
Grass catcher box
capacity: 55 l
MB 253.0 / MB 253.0 T:
18. Troubleshooting
# If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
@ See engine instruction manual.
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 253 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 253 in the language / languages: All languages as an attachment in your email.

The manual is 11,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info